Erasing the Sensor from a Zone
Note: If you need to remove the Sensor from a Zone, the system will erase the entire Zone, so any other Sensors will need to be put back into that particular Zone.
Step 1 - To erase a Zone, press and hold the Learn button on the Control Center. The unit will beep once.
Step 2 - While holding the Learn button, press and hold the Zone button to be erased. After five seconds the Control Center will sound two beeps and the Zone LED indicator will flash twice.
Step 3 - Release all buttons. The Zone has been erased.
Note: The Zone/Motion Sensor cannot be erased if:
-The Zone has been triggered for an Alert or alarm. The Sensor/Zone must be reset.
-There is loss of signal from the Sensor to the Control Center (such as low battery, or Sensor is out of range).
-The system is armed.
The Control Center will sound three beeps to indicate it could not erase the Zone.
Low Battery Indicator
The Control Center continuously monitors all the Sensors. If the Control Center does not receive a signal from any Sensor it will begin rapidly flashing the Zone LED indicator . This indicates one or more Sensors in the Zone may have low battery power and are unable to transmit a signal the necessary distance. If all batteries and/or Sensors are installed at the same time into a Zone, it is recommended to replace the batteries in all Sensors in the Zone.
