Jasco 99003 user manual Pairing Mode

phone on the headset. Phones that do not support ring indication will automatically accept the call.

When using the GE99003 headphones with a music source and a phone at the same time, the headphones should be paired with the phone before pairing with the audio device.

Pairing Mode

The pairing mode allows your 99003 headset to pair (connect) with Bluetooth enabled transmitters.

1.With the headphones OFF, press and hold the power button for a total of 6 seconds to turn the headphones ON and enter the Discovery/Pairing Mode.

2.The two LEDs will fl ash in the following sequence: Blue – Red – Blue, pause, repeat.

3.First time pairing may take up to two minutes. If pairing fails, the 99003 headset will go into the standby mode. Turn the headset OFF and try again.

Pairing the headphones to a Bluetooth enabled phone for the first time

Use the phone’s menu system to pair it with your phone if you want to be able to use your 99003 stereo headphones as a hands-free headset. ”Pairing” creates a link between a Bluetooth- enabled phone and the GE 99003 stereo headphones. It allows the phone to remember the headset’s unique Bluetooth ID. You may add it to your phone’s “Paired Device” list. The headset needs to be paired only ONE time with the phone before use.

1.Power ON your GE 99003 headphones and activate the “Discovery/Pairing Mode” as directed above.

2.Make sure your Bluetooth enabled phone is turned on and within 6 feet of the headphones.

7