Sleep Feature
This feature will turn off your TV at the time you choose from 1 to 99 minutes.
Trouble Shooting
Problem | Solution |
|
|
Indicator light not blinking | A) Replace the batteries (with |
when you press any key | fresh, new AAA Alkaline |
To Program Sleep Feature:
1.Press and hold the SLEEP button. INDICATOR LIGHT will stay lit. Release the SLEEP button.
2.Enter time in minutes using the numerical key pad.
(Minutes 1 thru 9: press 0 before the actual number)
(Maximum: 99 minutes)
3.Leave remote aimed at television. (Sleep Feature will not work unless remote is left aimed at television.)
INDICATOR
LIGHT
SLEEP
1 2 3
4 5 6
7 8 9
0
A¥BSLEEP
|
| batteries). |
| B) | Check that batteries are |
|
| properly installed. |
|
|
|
The RM94902 does not | A) | Try all the codes listed for |
operate your device |
| your brand. |
| B) | Try the Code Search |
|
| method (page 11). |
|
| |
Not performing commands | Start Code Search over again to | |
properly | locate the proper code. | |
|
| |
Problems programming a | Try the VCR code for your | |
TV/VCR Combo Unit | brand. Some combo units, | |
| however, may require both a | |
| TV and a VCR code for full | |
| operation. | |
VCR not recording | As a safety feature on your | |
| remote, you must press the | |
| REC button twice. | |
|
| |
Channel up and down do not | Due to some designs, the |
To Turn Off The Sleep Timer:
Sleep timer program will be cancelled and reset to zero by either of the following:
Press and hold SLEEP button until INDICATOR LIGHT blinks or press POWER button, turning TV OFF.
POWER
SLEEP BLINK
function on an RCA TV | original remote will only | |
| perform these functions. | |
Problems changing channels | If your original remote required | |
| ENTER after a channel, press | |
| ENTER after you select a | |
| channel. | |
|
|
|
No response after pressing | A) | Make sure you have new |
a key |
| batteries, and you are |
|
| aiming your remote at |
|
| your devices. |
| B) | Check that batteries are |
|
| properly installed. See |
|
| page 3. |
|
| |
Sleep feature does not work | Remote must remain aimed at | |
| television after sleep is set in | |
| order for it to work. |
Reprogramming may be required after batteries are removed.
12 | 13 |