JBL 500GTi, 400GTi manual Wiring, Use 2-conductor stranded type

FABRIC DISPLACEMENT RING

Logo Orientation on Grille

The orientation of the logo on the grille relative to the grille frame can be adjusted. Simply remove the metal grille and reassemble the metal grille to the grille frame utilizing a different tab slot.

GRILLE

FRAME

to the amplifier. A minimum wire gauge of 18AWG is recommended, with larger size wire suggested for runs longer than 10 feet. The polarity (the positive / negative

orientation of the connections) for every speaker-to-amplifier connection must be consistent from left to right channel to assure proper imaging and optimum frequency response. This does not mean

Figure B

Note: The metal grille is designed so that it can be covered with grille cloth if desired. Simply remove the metal grille from the grille frame as shown in Figure C. Then use spray adhesive to glue and wrap the grille cloth to the metal grille. Push the metal grille with cloth back in the plastic trim ring. For even better interior matching it is also possible to use plastic compatible paint to match the grille frame to the

Figure C

METAL

GRILLE

Wiring

Use 2-conductor stranded type,

tweeter

JBL 08GTi

midrange

JBL 400GTi

midbass

JBL 600GTi

woofer

JBL 1200GTi

tweeter

JBL 08GTi

midrange

JBL 400GTi

midbass JBL 600GTi

AMPLIFIER

AMPLIFIER

AMPLIFIER

AMPLIFIER

PASSIVE

X-OVER

ACTIVE	HEAD
X-OVER	UNIT

AMPLIFIER	HEAD
	UNIT

Figure D

vehicle’s interior.

insulated wire to connect the 400 and 500GTi to its crossover, and the crossover

woofer

JBL 1200GTi

7