GRILLE
FRAME
METAL
GRILLE
Figure E
Logo Orientation on Grille
The orientation of the logo on the metal grille relative to the grille frame can be adjusted. Simply remove the metal grille and reassemble the metal grille to the grille frame utilizing a different tab slot.
Mounting the
408 and 508GTi Tweeter
The 408 and 508GTi Tweeter includes accessories for four different mounting configurations. Take a look at all the possibilities described in the following paragraphs, pick one, follow the steps and you’ll soon be done!
mounting screws to secure the mounting plate in place as shown in Figure F.
b)Run wire from the 408 and 508GTi Crossover to the wire
c)Push the tweeter down onto the mounting plate making sure to line up the bayonet tabs with the slots in the tweeter housing.
d)Twist the tweeter clockwise about 1⁄4" to lock it into position.
Note: The metal grille is designed so that it can be covered with grille cloth if desired. Simply, remove the metal grille from the grille frame as shown in Figure E. Then use spray adhesive to glue and wrap the grille cloth to the metal grille. Push the metal grille with cloth back in the grille frame. For even better interior matching it is also possible to use plastic compatible paint to match the grille frame to the vehicle’s interior.
Tweeter Surface Mounting | C |
| |
Instructions | B |
a) Using the Mounting Plate Template at |
|
the back of this manual. Pick a mounting |
|
location for the tweeter making sure that |
|
speaker wire can be run to this location. |
|
Flat surfaces work best. Drill the holes as |
|
shown on the template in the desired | A |
mounting location. Use three 3⁄4" | Figure F |
|
TWEETER SURFACE MOUNT INSTALLATION
8
