![](/images/new-backgrounds/1131972/13197211x1.webp)
Mounting Instructions
Pick a mounting location after reading the recommendations in the Component Placement section of this manual.
Installing the GTi System Crossover
The GTi system crossover should be mounted securely to prevent damage to the crossover or possible loosening of wiring connections. Choose one of the crossover mounting methods and follow the directions below:
2.Remove the crossover board from the plastic case.
3.Use wire ties to secure the plastic case to the desired location as shown in Figure A.
4.Cut off the excess plastic on the wire ties.
5.
6.
3.Mark 4 hole locations, drill holes and secure the bottom cover to the desired mounting location as shown in Figure B. Before starting make sure no electrical or other critical car components are located where you will be drilling.
4.
5.
Note: Do not mount the GTi Crossover in a location where it can get wet, as this may cause damage to its components.
Figure A
Mounting the GTi Crossover with Wire Ties
1.Remove the crossover cover as shown in Figure L.
Figure B
Mounting the GTi Crossover with Screws
1.Remove the crossover cover as shown in Figure L.
2.Remove the crossover board from the plastic case.
MOUNTING RING
ADAPTER
Figure C
WOOFER/ MIDRANGE
6