![](/images/new-backgrounds/1257924/25792449x1.webp)
7.Connect the wires to the terminal assembly and place the speaker on the
IMPORTANT: Make sure all equipment is turned off before making
any connections. For speaker connections, use a
NOTE: If desired, consult your local JBL dealer about speaker wire and connection options.
4-CHANNEL WIRING
1.Run the four sets of paired wires out the wire access holes, as shown.
NOTE: This procedure is applicable for both large- and
Drop Tube
1.Strip 1/4" of wire
2.Press and push connector
3.Insert bare end; release push connector
BLACK = —
RED = +
The speakers have coded terminals that accept a variety of wire connectors. The most common connection is shown in the diagram to the left. To ensure proper polarity, connect each + terminal on the back of the amplifier or receiver to the respective + (red) terminal on each speaker, as shown. Connect the
–(black) terminals in a similar way. See the owner’s guides that were included with your amplifier, receiver and television to confirm connection procedures.
Wire Access Holes
4-Channel wiring.
2. Connect the wires to the terminal assembly of each speaker, as shown, |
and place the speaker on the mounting bracket, as shown in step 6 of the |
IMPORTANT: Do not reverse polarities (i.e., + to – or – to +) when making connections. Doing so will cause poor imaging and diminished bass response.
Standard
Connection
|
| Wiring diagram shows |
|
| polarity connections for |
|
| one channel of a stereo or |
RED = + | BLACK = — | home theater system. |
procedures and continue. |
Figure 36.
25