JBL CVSUB50 Mounting Options, Satellites And Surrounds, Important Safety Notes, the warranty

MOUNTING OPTIONS

SATELLITES AND SURROUNDS

On shelves using the optional CVTS50 table stands.

On the wall. Wall brackets are included.

On compatible floor stands avail- able from other manufacturers, using the supplied floor stand adaptors.

ATTACHING THE CVTS50 TABLE STAND (AVAILABLE SEPARATELY) TO THE CVSAT50

Important Safety Notes:

•The table stand consists of two main parts: a metal col- umn and a glass base. Be extremely careful in han- dling the fragile glass base to avoid breakage that might result in personal injury.

•The CVTS50 table stands are only intended for use with the CVSAT50 speaker. Attempting to use the stands with any other model speaker is unsafe and may result in personal injury and damage to the equipment.

•The stands must be placed in a safe location, protected from young children and pets who might topple the stands, possibly resulting in serious injury. Never place the stand so that any part of it is sticking out over the edge of the table, shelf or other surface underneath it.

•Do not install the CVSAT50 or any other speaker on the table stand in a horizontal orientation, as this would be unstable and might result in personal injury.

Carefully insert the glass base into the slot in the column,

lining up the holes in the base with the holes in the bottom of the col- umn. Screw in the bolts, mak- ing sure the plastic washers are between the bottom of the glass base and the bolt heads. Tighten the bolts securely using a Philips screwdriver (not supplied). Do not overtighten, as this might strip the threads, which is not covered by

the warranty.

Prepare the speaker wire as described on page 8. Remove the rubber strip from the back of the column,

revealing the wire-manage-

ment channel. Thread the two conduc-

tors through the hole at the top of the channel. Make sure to preserve the proper polar-

ity (+ and – connections) by placing the positive conduc- tor on the left, and the nega- tive conductor on the right, looking at the front of the stand column.

Use the supplied terminal wrench to loosen the red col- lar of the binding post until the pass-through hole under- neath it is revealed. Insert the bare end of the positive wire through the hole, then screw the collar down until it is tight. Follow the same procedure to connect the negative wire to its terminal. Slowly lower the mounting bracket on the satellite onto the top

of the metal col-

umn of the CVTS50 stand. Gently pull

the slack out of the

wire. Carefully press the rubber strip in place over

the wire-manage- ment channel,

being careful to keep the speaker wire in the channel and to avoid pinch-

ing it with the rubber strip.

5