MOUNTING THE SATELLITES ON OPTIONAL FLOOR STANDS
Important Safety Note: The supplied floor stand adaptors facilitate installation with a variety of general- purpose floor stands available from many manufacturers. Since different stands will have different weight capaci- ties and stability characteris- tics, it is the customer’s responsibility to check with the stand manufacturer or dealer to ascertain whether that specific stand is capable of handling the weight and proportions of these loud- speakers in a safe and stable manner. JBL disclaims any liability for the selection
of suitable floor stands and/or correct compatibility between the selected stand and the supplied stand adaptor.
The floor stand adaptors are compatible with floor stands equipped with a
Using a suitable bolt supplied with the stand (or by you), attach the floor stand adaptor to the stand by screwing the bolt through the hole in the bottom tab of the adaptor and into the threaded insert at the top of the stand. Orient the adaptor so that the upright portion faces toward the listening position.
Prepare the speaker wire as described on page 8, and thread it through the floor stand’s wire management system (if any), as instructed in the owner’s guide for the stands. Make sure to pre- serve the proper polarity
(+ and – connections). Use the supplied terminal wrench to loosen the red col- lar of the binding post until the
Slowly lower the mounting bracket on the satellite onto the top of the floor stand adaptor until the metal spring clip engages in the squarish opening on the front of the adaptor.
Gently pull the slack out of the wire, and slide the floor stand cover over the adaptor for a smooth appearance.
6
