JBL EVO1.324 manual Important Safety Information Read this Carefully

IMPORTANT SAFETY INFORMATION - READ THIS CAREFULLY

This equipment has been tested and found to comply with the following European and international standards for Electromag- netic Compatibility and Electrical Safety:

Radiated Emmissions (EU): EN55022B (1992)

RF Immunity (EU): IEC801-3 (1994)

Electrostatic Discharge(EU): IEC801-2 (1984)

Fast Transients(EU): IEC801-4 (1988)

Electrical Safety (EU): EN60065 (1994)

Electrical Safety(USA): UL6500/ETL (1996)

Electrical Safety(CAN): CAN/CSA-E65/ETLc (1996)

Before using the apparatus read these instructions, follow all instructions, heed them and keep in a safe place.

Clean only with a damp cloth. Do not block any of the ventilation openings. Install in accordance with the manufacturer’s instructions.

Do not defeat the safety purpose of the grounding type plug. A grounding plug has two blades and a third grounding prong. The third prong is provided for your safety. When the provided plug does not fit into your outlet, consult an electrician for replace- ment of the obsolete outlet.

Protect the power cord from being walked on or pinched particularly at plugs, convenience recepticals and the point where they exit from the apparatus.

Only use attachments/accessories specified by the manufacturer.

Unplug this apparatus during lightning storms or when not in use for a long time.

WARNING – TO REDUCE THE RISK OF FIRE OR SHOCK, DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOISTURE.

DO NOT REMOVE COVERS, NO USER SERVICABLE PARTS INSIDE, REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

THIS EQUIPMENT MUST BE GROUNDED.

!	CAUTION	ATTENTION
	RISK OF ELECTRONIC SHOCK	RISQUE DE CHOC ELECTRIQUE
	DO NOT OPEN	NE PAS ENLEVER
	DO NOT EXPOSE	NE PAS EXPOSER A
	TO RAIN OR MOISTURE	LA PLUIE NI L'HUMIDITE

IT SHOULD NOT BE NECESSARY TO REMOVE ANY PROTECTIVE GROUND OR SIGNAL CABLE SHIELD CONNECTIONS TO PREVENT GROUND LOOPS. ANY SUCH DISCONNECTIONS ARE OUTSIDE THE RECOMMENDED PRACTICE OF JBL PROFESSIONAL AND WILL RENDER ANY EMC OR SAFETY CERTIFICATION VOID.

For continued compliance with international EMC legislation ensure that all input and output cables are wired with the cable screen connected to Pin 1 of the XLR connectors. The input XLR Pin 1 is connected to the chassis via a low value capacitor, providing high immunity from ground loops while ensuring good EMC performance.