JBL EVO1.324 manual EVOi.324 Rear, Output on Generic Mixer EVOi.net Rear, EVOi.sys Rear

H O O K - U P D E T A I L S

AUDIO AND AC POWER CONNECTIONS

EVOi.324 Rear

Power

Input OR

OR

Output on Generic Mixer EVOi.net Rear

Sensitivity (direct in) +10 dBu assuming no EQ has been applied.

XLR Signal Cable

EVOi.sys Rear

AC Main Power Cord (supplied)

AC Mains

Fuse

Figure 3 - Basic EVOi.324 Audio and AC Connections

Maximum Drive Level = +10 dBu * Sensitivity

There are three simple audio hook-up options: all require the use of high quality balanced signal cable with a Male XLR connector. EVOi.324 requires a drive level of +10 dBu (sensitivity = +10 dBu assuming no external equaliza- tion has been applied to the signal) for maximum perfor- mance. Hooking a microphone directly to the input will NOT drive it sufficiently. The output of a standard mixer, EVOi.net or EVOi.sys should provide the optimum drive level. (See the Sensitivity Chart in the Appendix, page 21)

Power Requirements

IMPORTANT: Each individual EVOi.324 is an extremely powerful system and is quite capable of drawing peak currents of up to 18 amps. Please consult a qualified electrician for correct installation and power connection. For more information, see AC Requirements on page 21.

CAUTION: to reduce the risk of fire, replace fuse with

same type and rating: ATTENTION: utiliser un fusible de rechange de meme type de:

115V~ T6.3A/250V~

230V~ T3.15A/250V~

* 0 dBu = 0.775 Volts; +10 dBu = 2.45 Volts

6

Power Cycle (Boot-up) Times

EVOi.324’s internal DSP (Digital Signal Processor) circuit board includes software applications. Like any device operating software programs, there is a “boot-up” time lag before EVOi.324 becomes fully operational. The audio

signal will be muted until the loudspeaker is fully booted up. This should take approximately 20 seconds.

Upon connecting AC mains, the green power indicator will illuminate. After approximately 20 seconds there will be a

!very quiet click as the system releases the mute. Upon power disconnection, the

green power indicator will flash several

times, however signal shut-down is instantaneous. In summary, boot-up time is approximately 20 seconds and shut-

down time is 0 seconds.

WARNING! When EVOi.324 is on, the amplifier heatsink will get hot even when no signal is being passed. This is normal operation for D-Class amplifiers.

EVOi.324