JBL GTQ240 owner manual Specifications, GTQ360

Specifications

	GTQ360	GTQ240
Power Output	60 Watts x 4 (4 Ohms, 0.05% THD)	45 Watts x 4 (4 Ohms, 0.05% THD)
(20Hz – 20kHz,	90 Watts x 4 (2 Ohms, 0.08% THD)	60 Watts x 4 (2 Ohms, 0.08% THD)
14.4V Battery Voltage)	180 Watts x 2 (Bridged 4 Ohms, 0.08% THD)	120 Watts x 2 (Bridged 4 Ohms, 0.08% THD)
Signal-to-Noise Ratio	100dBA	100dBA
Frequency Response	10Hz – 50kHz (+0, –1dB)	10Hz – 50kHz (+0, –1dB)
	20Hz – 20kHz (+0, – 0.1dB)	20Hz – 20kHz (+0, – 0.1dB)
Damping Factor	> 200	> 200
Slew Factor	> 5	> 5
Line-Level Input Sensitivity	100mV – 4V RMS	100mV – 4V RMS
(For Rated Power)
Line-Level Input Impedance	10k Ohms	10k Ohms
Speaker-Level Input Impedance	15 Ohm or 100k Ohm	15 Ohm or 100k Ohm
	(Selectable by Internal Jumpers)	(Selectable by Internal Jumpers)
Speaker-Level Input Sensitivity	200mV – 8V RMS	200mV – 8V RMS
Preamp Output Level
Preamp Input:	V out = V in	V out = V in
Speaker Input:	V out = 1/2 V in	V out = 1/2 V in
Minimum Speaker Impedance
Single-Ended (Non-Bridged):	2 Ohms	2 Ohms
Bridged:	4 Ohms	4 Ohms
Built-in Electronic	18dB per Octave Low-Pass Filter,	18dB per Octave Low-Pass Filter,
Crossover Frequency and Slope	Frequency Chips Available from 50Hz – 5kHz	Frequency Chips Available from 50Hz – 5kHz
	Factory Setting: 80Hz	Factory Setting: 80Hz
	18dB per Octave High-Pass Filter,	18dB per Octave High-Pass Filter,
	Frequency Chips Available from 50Hz – 5kHz	Frequency Chips Available from 50Hz – 5kHz
	Factory Setting: 80Hz	Factory Setting: 80Hz
Bass Boost Frequency and Magnitude	+4dB at 40Hz	+4dB at 40Hz
Mute Trigger Voltage	5V to 12V	5V to 12V
Power Requirement	11 to 16V DC Negative Ground	11 to 16V DC Negative Ground
Fuse Size	30 Amp ATC Type Fuse (2 per Amplifier)	40 Amp ATC Type Fuse
Size (HxWxL)	2 x 11-1/4 x 14"	2 x 11-1/4 x 12"
	(51 x 286 x 356mm)	(51 x 286 x 305mm)
Weight	13.5 lbs (6.12 kg)	11.1 lbs (5.03 kg)
Speaker-Level Input	Molex Mini-Fit Jr	Molex Mini-Fit Jr
Mating Connector	#39-01-2080	#39-01-2080
	Metal Pins: 39-00-0038	Metal Pins: 39-00-0038

11