JBL MS9200 Installation Warnings And Tips, About These, Loud Music And, About Power, Instructions

ENGLISH

INSTALLATION WARNINGS AND TIPS

ABOUT THESE	LOUD MUSIC AND	ABOUT POWER
INSTRUCTIONS:	HEARING:	HANDLING:
Installation of marine audio	Playing loud music in a marine	JBL marine speakers will produce
components can require extensive	environment can permanently	reasonable volume levels with little
experience with a variety of	damage your hearing, as well as	amplifier power. Moreover, adding
mechanical and electrical	hinder your ability to hear marine	an amplifier to drive your speakers
procedures. Although these	traffic. The maximum volume levels	and a subwoofer will enhance your
instructions explain how to install	achievable with JBL speakers,	system’s dynamic range and help
JBL marine speakers in a general	combined with high-power	overcome ambient noise.
sense, they do not show the exact	amplification, may exceed safe
installation methods for your	levels for extended listening.	Although JBL marine speakers are
particular application. If you do not	JBL accepts no liability	designed to handle the power of a
feel you have the experience, do	for hearing loss, bodily injury or	dedicated amplifier driven at or
not attempt the installation yourself.	property damage as a result of	below its rated power, make sure
Ask your authorized JBL marine	use or misuse of this product.	the amplifier is not driven far above
audio dealer about professional		its rated power. Doing so will “clip”
installation options.	GENERAL CARE:	the output signal and can damage
	The loudspeaker grilles may be	any speaker. Distorted or “fuzzy”
	cleaned with a damp cloth. Do not	sound from your speakers is an
	use any cleaners or solvents on the	indication that the amplifier has
	grilles or the speaker cones.	exceeded its rated power, and you
		should reduce the volume level.

INSTALLATION TIPS:

•Always wear protective eyewear when using any tools.

•Turn off all audio components and other electrical devices before you start. Disconnect the negative (–) lead from your battery.

•Keep speakers in their package until final installation. When mov- ing a speaker, always rest it with the cone or dome facing up. Never use force to install any speaker.

•Check clearances on both sides of a planned mounting surface before drilling any holes or installing any screws. Remember that the screws can extend behind the surface.

•At the installation sites, locate and make a note of all fuel lines and electrical wiring. Use extreme caution when cutting or drilling in and around these areas.

•Before drilling or cutting holes, use a utility knife to remove unwanted fabric or vinyl to keep material from snagging in a drill bit or saw.

•The stainless-steel hardware provided with your JBL marine speakers has been chosen to resist rust and corrosion.

2