3.0 | 3.0 |
OPERATION AND | OPERATION AND |
CONTROLS | |
CONTROLS |
|
S 8 0 0 |
3.1 S800
1. Power Switch
Pushing this button is all that is required to turn on the S800 if it is not part of a Synthesis system and the Manual On/Auto On switch (rear panel) is in the Manual On position. If the amplifier is used as part of a JBL Synthesis System, and the Manual On/Auto On switch is in the Auto On position, the amplifier will turn on when the surround processor is activated. The front panel pushbutton power switch is left in the ON (in) position..
2. Standby Indicator (red)
This indicator, immediately above the front panel power switch, will glow red when the amplifier is in the "standby" mode, whether operating as part of a Synthesis system or not. When the S800 is in the "operate" mode, this light will shut off and the blue "operate" mode indicators will light.
3. Power Indicators (blue)
These indicators will light up when the power amplifier is in the "operate" mode. Each monitors the operation of one channel, and will extinguish if that channel’s protective circuit is activated.
4.Input Jacks (Ch.1 and Ch.2) (see page 11) If you are using the S800 as a stereo power amplifier, connect the signal output(s) from the system equalizer or surround processor to these jacks and set the Stereo/Mono switch to the Stereo position. If you are using the S800 in the bridged mode, connect the subwoofer signal output from the equalizer to the Ch.1 jack only, and put the Stereo/Mono switch in the Mono position.
5.Stereo/Mono Switch
See paragraph 4 above
6. Speaker Terminals (see page 11)
Connect the speakers to these terminals, following the normal convention; wire the "+" side of the speaker to the red terminal, and the
In mono mode, connect the speaker to the center red terminals only; no connection is made to the
10
