JBL S800 Operation And Controls, Auto On/ Manual On Switch, 9. IN/OUT Din Jacks, AC Inlet

3.0

OPERATION AND

CONTROLS

8. Auto On/ Manual On Switch

Put this switch in the Auto On position if the amplifier is being used as part of a JBL Synthesis System. When used in this way, the S800 will automatically turn on when the power switch is depressed and the surround processor is activated. For other installations, or should individual control of each component be desired, put this switch in the Manual On position. The amplifier will then be controlled solely by the front panel switch.

9. IN/OUT Din Jacks

If you are using the amplifier as part of a JBL Synthesis System, it is necessary to use these jacks to interconnect to other system components, so that control signals (power on/off and music/cinema mode switching) can be transmitted from one unit to the next, starting at the surround processor, through the equalizer and amplifiers, and ending at the speakers. Follow the connection diagrams on the following pages corresponding to the appropriate Synthesis system for detailed information

OPERATION3.0AND

CONTROLS

regarding these connections. Make connections to these jacks only as shown in the diagrams. If these jacks are used in any other manner, e.g., to control electric screens, the unit can be damaged and the warranty will be void. For specific electrical information on these jacks, contact JBL Synthesis Customer Service at (800) 336-4JBL.

Do not plug anything into these jacks if you are not using the S800 with a JBL Synthesis System.

10. AC Inlet

Your S800 is shipped with an IEC-type removable power cord that mates with the AC inlet on the rear panel. To ensure proper operation, use the supplied power cord. This amplifier is NOT a multi-voltage unit; using a power cord with a different connection to the AC wall receptacle will void the warranty.

12