JBL SCSSAT300 manual Wall-Mounting

WALL-MOUNTING
4	3			between the Metal Nut ¡
		2		and the back of the Satellite
				Speaker ¶, using large
		1		needle-nose pliers until it is
				firmly seated against the back
				of the Speaker ¶ and has
8				locked the Ball and Shaft £
	5			and the Speaker ¶ together.
				Note that once the Metal Nut
				¡ is fully tightened, it may
				embed some marks on the
Important Safety Note: The		Step 3: Slide the Molded Nut		back of the Satellite Speaker
				¶. However, these marks
customer is solely responsi-		™ onto the Ball and Shaft		will be covered by the Metal
ble for proper selection of		£ with the threaded open-
				Nut ¡.
mounting hardware not		ing facing the ball. Thread
				Step 6: Mount the Attach-
included with the speaker,		the Metal Nut ¡ all the way
and for proper assembly		onto the Ball and Shaft £,		ment Plate ¢ into a wood
and installation of the wall
bracket, including but not
limited to the selection of			7
appropriate weight-bearing
supports and proper use of			6	1	2
the bracket. JBL disclaims
any liability for the selection						3	4
of mounting hardware
and/or bracket installation.
Be sure to follow these				5
bracket assembly and					8
installation instructions
carefully. If you have any
questions or doubts about				stud on the wall, using four
your ability to correctly wall-		with the star washer side
mount the speakers, consult		away from the ball. Refer to		#10 pan-head wood screws
with your authorized JBL		the exploded drawing for the		at least one inch long (not
dealer or custom installer.		proper orientation of these		supplied) •. Make sure that
Step 1: Unscrew and remove		parts.		all four screws are driven
		Step 4: Screw the Ball and		into the stud and not into
the large Molded Nut ™. If
				drywall. If the bracket needs
		Shaft £ into the Threaded
necessary, use the supplied
				to be mounted in drywall,
		Insert § on the back of the
Metal Bar ∞ as a lever by
				the customer is responsible
		Satellite Speaker ¶ until
inserting it into one of the
				for selecting and using
		it is fully seated in the
holes in the outer edge of
				appropriate wall anchors
		Threaded Insert §, but
the Molded Nut ™.
				and screws.
		do not tighten, as you might
Step 2: Firmly grasp the Ball
		dislodge the Threaded Insert		Important Note: The Metal
and Shaft £ and pull it
		§. Such damage would		Nut ¡ must be fully tight-
straight out of the Attach-
		not be covered under the		ened against the Satellite
ment Plate ¢. Avoid leaning
		warranty.		Speaker ¶ as described in
it to the side for leverage, as
		Step 5: Tighten the Metal Nut		Step 5 before beginning Step
this may break off a tab.
		¡ with the star washer side		7 in order to avoid damage
4				to the Threaded Insert §.