JBL SCSSAT300 manual Attaching The Shelf Stand To The Speaker

ATTACHING THE SHELF STAND TO THE SPEAKER

Prepare the speaker wire as described on page 5. Thread the two conductors through the two holes in the stand bracket. Make sure to pre- serve the proper polarity

(+ and – connections) by threading the positive con- ductor through the hole on the left, and the negative

+–

conductor through the hole on the right looking at the stand from the front. Push down on the red speaker terminal and insert the bare end of the positive wire into the hole under the red cap. Release the cap, and tug gently on the wire to make sure that the connection

Gently pull the slack out of the wire and screw the shelf stand onto the back of the speaker in two places, as shown.

is snug. Follow the same procedure to connect the negative wire to its terminal. Use the larger screw (Hardware Bag A) in the upper screw hole, and the smaller screw (Hardware Bag A) in the lower screw hole.

MOUNTING THE SATELLITES ON OPTIONAL FLOOR STANDS

Important Safety Note: The supplied floor stand adapters facilitate installation with a variety of general-purpose floor stands available from many manufacturers. Since different stands will have different weight capacities and stability characteristics, it is the customer’s responsibil- ity to check with the stand manufacturer or dealer to determine whether that spe- cific stand is capable of han- dling the weight and propor- tions of these loudspeakers in a safe and stable manner. JBL disclaims any liability for the selection of suitable floor stands and/or correct compat- ibility between the selected stand and these satellite loud- speakers.

The floor stand adapters are compatible with floor stands equipped with a 1/4"-20 threaded insert.

Prepare the speaker wire as described on page 5. Thread the two conductors through the two holes in the floor stand adapter. Make sure to preserve the proper polarity (+ and – connections) by threading the positive conductor through the hole on the left, and the nega- tive conductor through the hole on the right (looking at the front of the adapter). Push down on the red speaker ter- minal and insert the bare end of the positive wire into the hole under the red cap. Release the cap, and tug gen- tly on the wire to make sure that the connection is snug. Follow the same procedure to

+–

connect the negative wire to its terminal.

Gently pull the slack out of the wire and screw the adapter onto the back of the speaker in two places, as shown.

The floor stand adapter screws may be found in Hardware Bag B. Use the larger screw in the upper screw hole, and the smaller screw in the lower screw hole.

Screw the floor stand adapter into the floor stand’s threaded insert until the speaker is firmly attached to the stand. Back off slightly from the fully tightened position until the speaker is oriented as desired, then rotate the thumbwheel at the bottom of the floor stand adapter to secure the speaker to the stand.

3