AA68-03388A-00_eng_Chapter2 4/21/04 5:24 PM Page 18

IN S TA L L AT I O N

Connecting a VCR

These instructions assume that you have already connected your TV to an antenna or a cable TV system (according to the instructions on pages 14~17). Skip step 1 if you have not yet connected to an antenna or a cable system.

TV Rear Panel

1

Unplug the cable or antenna from the back of the TV.

2

Connect the cable or antenna to the

ANTENNA IN terminal on the back of the

VCR.

3

Connect a coaxial cable between the ANTENNA OUT terminal on the VCR and the antenna terminal on the TV.

4

Connect a set of audio cables between the AUDIO OUT jacks on the VCR and the AUDIO jacks (AV1~AV3) on the TV.

If you have a “mono” (non-stereo) VCR, use a Y-connector (not supplied) to hook up to the left and right audio input jacks of the TV. If your VCR is stereo, you must connect two cables.

5

Connect a video cable between the

VIDEO OUT jack on the VCR and the

VIDEO jack (AV1~AV3) on the TV.

Follow the instructions in “Viewing an External Signal Source” to view your VCR tape.

Ferrite Core

TV Rear Panel

The ferrite core is used to attenuate undesired signals. When connecting cables, attach the ferrite core to the cable near the connec- tor.

18