JBL Simply Cinema setup guide SCS125 System, sat125, sub125, Troubleshooting, Specifications

Troubleshooting

If there is no sound from any of the speakers, check the following:

•Receiver/amplifier is on and a source is playing.

•Powered subwoofer is plugged in and is either in the “On” or “Auto” position.

•Check all wires and con- nections between receiver/ amplifier and speakers. Make sure all wires are connected. Make sure none of the speaker wires are frayed, cut or punctured.

•Review proper operation of your receiver/amplifier.

If there is no sound coming from one speaker, check the following:

•Check the “Balance” control on your receiver/amplifier.

•Check all wires and con- nections between receiver/ amplifier and speakers. Make sure all wires are connected.

Make sure none of the speaker wires are frayed, cut or punctured.

If the system plays at low volumes but shuts off as volume is increased, check the following:

•Check all wires and con- nections between receiver/ amplifier and speakers. Make sure all wires are connected. Make sure none of the speaker wires are frayed, cut or punctured.

•If more than one pair of main speakers is being used, check the minimum imped- ance requirements of your receiver/amplifier.

If there is low bass output, check the following:

•Make sure the connections to the left and right “Speaker Inputs” have the correct polarity (+ and –).

•Make sure that the sub- woofer is plugged into an active electrical outlet.

•Powered subwoofer is plugged in and is either in the “On” or “Auto” position.

If there is no sound from the surround speakers, check the following:

•Check all wires and con- nections between receiver/ amplifier and speakers. Make sure all wires are connected. Make sure none of the speaker wires are frayed, cut or punctured.

•Review proper operation of your receiver/amplifier and its surround sound features.

•Make sure the movie or TV show you are watching is recorded in Dolby surround. If it is not, check to see if your receiver/amplifier has other surround modes you may use.

Specifications

SCS125 System	sat125	sub125
Frequency Response	Recommended Power	Amplifier
35Hz – 20kHz (–6dB)	10 – 50 watts	75 watts RMS
	Impedance	Bass
	8 ohms nominal	8" woofer, bass-reflex
	Sensitivity	enclosure
	86dB @ 1 watt/1 meter	Dimensions (H x W x D)
	Tweeter	14-1/8 x 13 x 13 inches
	One 1/2"-dome, video	359 x 330 x 330mm
	shielded	Weight
	Midrange	27.5 lbs/12.5 kg
	3" driver, video shielded
	Dimensions (H x W x D)
	4-3/8 x 3-3/16 x 3-3/4 inches
	111 x 81 x 95mm
	Weight
	1 lb/.45 kg
Refinements may be made on
occasion to existing products
without notice, but will always
meet or exceed original speci-
fications unless otherwise
stated.