How TO REVERSE REFRIGERATOR DOOR
DOORS WITH TRIM AND
PANELS
I.Perform all steps listed in How to
Remove the Door and Hinges.
2.Perform removal stepslistedin How to Remove and Install Handles.
3.Transfer cabinet
plugs and screwsto
opposite side of cabinet
4.Remove plugs with
flat blade of i
screwdriver wrapped in masking tape.
5.Remove center mullion screws with Y_6"hex headdriver.
6.Locatedoor stop (B)anddoor cap(A) on bottom edge of freshfood door. Removewith a Phillipsscrewdriver.
•Retainallitemsfor laterreplacement
7.Remove side door trim (A) and handle side trim (13)from door by
tapping bottom edges upward with a soft rubber mallet.
•Trim will slide up approximately Y4" and release from
8, Rotate door panel 180° and tape in place.
9. door.
Remove top door extension with ¼" hex
head driver. Flip door
extension (A) so notched corner turns in toward interior of door (B).
10.Retrieve alternate side door trim shippedwith refrigeratorInstall.trim by aligningnotches of trim with metalmountingtabs on sideof door.
•Slidetrim down until piece locks into place.
•Tap top of trim with rubber mallet to insuresnugfit_
•Repeat sameprocedure to install handlesidetrim removed instep 7.
II.Replace bottom door cap (A) removed in step 6. Installdoor stop
(B) on opposite side of door.
B
12.Removetapefrom panels.
13.Proceed to next columnto reinstall handle.
How TO INSTALL AND
REMOVE HANDLES
In some cases, handles may need to be removed to transport unit through tight spaces,reverse doors, or install panels.
Some models may come with handles shipped separate from the refrigerator door.
INSTALLING HANDLES
I. Retrieve handle from shipping
material (somemodels). |
| |
2. Locate | handle |
|
mountingposts on _ | j | |
faceof door. | i | |
|
| |
3.Position handle over mounting J posts.
4.Tighten set screws(A) _ with a Y_2 Allen _
wrench/
REMOVING HANDLES
I.Locate set screws in handleand loosen set screws with a Y32"Allen wrench.
2.Lift handle from handle mounting posts to remove.
5
