Jenn-Air 2300279C manual Refrigerator USE, Refrigerator Features

Base Grille

Remove the Base Grille

1.Open the refrigerator door.

2.Using a Phillips screwdriver, remove the two screws. Push both tabs in toward the center to release the base grille from the refrigerator.

ABA

A.Tabs

B.Screws

3.Remove the base grille.

Replace the Base Grille

1.Open the refrigerator door.

2.Position the base grille so that both tabs align and the base grille snaps into place. Replace the two screws. Tighten the screws.

REFRIGERATOR USE

Normal Sounds

Your new refrigerator may make sounds that your old one didn’t make. Because the sounds are new to you, you might be concerned about them. Most of the new sounds are normal. Hard surfaces, such as the flooring and surrounding structures, can make the sounds seem louder. The following describes the kinds of sounds and what may be making them.

■Your refrigerator is designed to run more efficiently to keep your food items at the desired temperatures and to minimize energy usage. The high efficiency compressor and fans may cause your refrigerator to run longer than your old one. You may also hear a pulsating or high-pitched sound from the compressor or fans adjusting to optimize performance.

■Rattling noises may come from the flow of refrigerant or items stored inside the refrigerator.

■As each cycle ends, you may hear a gurgling sound due to the refrigerant flowing in your refrigerator.

■You may hear water running into the drain pan when the refrigerator is defrosting.

■You may hear clicking sounds when the refrigerator starts or stops running.

Using the Control

For your convenience, your refrigerator control is preset at the factory. When you first install your refrigerator, make sure that the control is still preset to the mid-setting as shown.

Adjusting Controls

The mid-setting indicated in the previous section should be correct for normal usage. The control is set correctly when beverages are as cold as you like.

If you need to adjust the temperature, wait at least 24 hours between adjustments and then recheck the temperature.

To make the refrigerator colder, adjust the control to the next higher setting. To make the refrigerator less cold, adjust the control to the next lower setting.

REFRIGERATOR FEATURES

Important information to know about glass shelves and covers:

Do not clean glass shelves or covers with warm water when they are cold. Shelves and covers may break if exposed to sudden temperature changes or impact, such as bumping. Tempered glass is designed to shatter into many small, pebble-size pieces. This is normal. Glass shelves and covers are heavy. Use both hands when removing them to avoid dropping.

Refrigerator Shelves

Your model may have glass or wire shelves. Store similar foods together and adjust the shelves to fit different heights. This reduces the time the refrigerator door is open and saves energy.

To Remove and Replace Shelves:

1.Remove the shelf by lifting it up and out of the shelf brackets. Remove the shelf.

2.Replace the shelf by inserting it into the shelf brackets. NOTE: Be sure the shelf is level.

Lower Shelf

To Remove and Replace Lower Shelf:

1.Remove the shelf by lifting it up and pulling it forward.

2.Replace the shelf by lowering it on the guides.

8