WARNING
Improper installation of the grounding circuit can result in a risk of electric shock.
Consult a qualified electrician or serviceman if the grounding instructions are not completely understood, if doubt exists as whether the appliance is properly grounded.
CAUTION
For European style cabinets (flush front) the required clearance for operation of the oven door is minimum spacing of 7/8 between the cutout and the door, hinge or drawer of the cabinet.
Some
Installation
1.Cut hole in cabinet to mount oven. Cutout in cabinet should be level and straight.
NOTE: There are no provisions to level the unit after it is installed. An oven that is not level could cause poor baking results.
2.Install plywood floor as shown.
3.Remove oven door(s). See Oven Door Removal procedure.
4.Attach unit to the cabinet with four No. 8 x 1 screws supplied with unit inside of envelope containing these instructions.
5.Install bottom trim.
6.Replace oven door(s). See Oven Door Replacement procedure.
7.See instructions at right for electrical
8.See Use and Care Manual for operating instructions.
Installing Bottom Trim Piece
Remove lower screws from hinge receptacle plates. Align lower trim and reinstall screws.
DO NOT INSTALL BOTTOM TRIM UNTIL UNIT IS ATTACHED TO THE CABINET.
Electrical Connections
Unit to be properly circuit protected and wired according to local electrical code and National Electrical Code.
It is advisable that the electrical wiring and hookup be accomplished by a competent electrician.
120/240 VAC or 120/208 VAC 60 Hz. See serial plate on front of unit for power requirements.
The neutral of this unit is grounded to the frame through the green or solid grounding wire. (The green and the white wires are twisted together at the termination of the conduit.) If used on new
The chart below recommends the minimum circuit protection and wire size if the appliance is the only unit on the circuit.
K.W. RATING | RECOMMENDED MINIMUM | WIRE SIZE | ||
CIRCUIT PROTECTION | ||||
ON SERIAL PLATE | IN AMPERS | (AWG) | ||
0 | - | 4.8 | 20 | 12 |
4.9 | - | 6.9 | 30 | 10 |
7.0 | - | 9.9 | 40 | 8 |
10.0 | - | 11.9 | 50 | 8 |
12.0 | - 14.9 | 60 | 6 | |
|
|
|
|
|
Service
Interrupt the source of electricity to the unit when attempting to repair or service the oven. Failure to do this could result in a dangerous or even fatal shock.
IMPORTANT - SAVE FOR LOCAL ELECTRICAL INSPECTOR’S USE
2