Jenn-Air 8101P485-60 installation instructions Oven Door Removal, Oven Door Replacement

Oven Door Removal

For ease of installation, remove oven door(s) before placing unit into cutout. This will reduce the weight of the unit by about 35 pounds per door. Remove oven door(s) as follows:

SOpen oven door to the “Full Open” position (see Figure 1).

SRotate hinge locking lever DOWN, to unlock hinge from the unit (see Figure 2).

SClose oven door to the “Removal” position (until it stops; see Figure 3).

SGrasp the door firmly on each side and lift the door straight up and off the unit.

NOTE: The oven door is heavy. Be sure you have a firm grip before lifting the oven door off the unit.

Do not lift the door by the handle!

Hinge Locking Lever

(Locked Position)

Figure 1

Hinge Locking Lever

(Unlocked Position)

Figure 2

Figure 3

Oven Door Replacement

Replace oven door(s) after placing unit into cutout. Replace oven door(s) as follows:

SGrasp oven door firmly on each side, hold oven door at approximately a 30° angle and align oven door hinge arm (see Figure 4) with hinge receiver on unit (see Figure 5).

SInsert oven door hinge arm into hinge receiver until the hinge arm slots (see Figure 4) align with horizontal pins on the hinge receiver (see Figure 5) and place hinge arm onto the hinge receiver.

SOnce the hinge arms are resting on the hinge receiver pins (see Figure 3) open oven door slowly to the “Full Open” position (see Figure 2).

SRotate hinge locking lever UP to the locked position to secure the oven door to the unit (see Figure 1).

NOTE: Make sure that hinge locking lever is rotated fully UP to the locked position as shown (see Figure 1) before closing oven door.

CAUTION

Door will not close all the way and could fall off when opened if the hinge locking levers are not rotated fully UP to the locked position.

If hinge locking lever will not rotate fully UP to the locked position as shown (see Figure 1) then the hinge arm is not properly seated on the receiver. Rotate the hinge locking lever DOWN to the unlocked position (see Figure

2)and remove oven door as outlined in the Oven Door Removal procedure. Then replace the oven door as outlined in the Oven Door Replacement procedure, making sure that the hinge arm slots are fully seated on the horizontal pins in the hinge receiver.

SOnce the hinge locking lever is rotated fully UP to the locked position (see Figure 1) close the oven door.

Hinge Arm

Figure 4

Hinge Arm Slots

Hinge Receiver

Horizontal Pins

Figure 5

3