Frymaster M3000 MIB Replacement, AIF Replacement, LOV Generation II Technical Reference, Cover

LOV™ Generation II Technical Reference

MIB Replacement

The MIB controller is located inside the left cabinet (see image below). In normal operation, a cover hides the MIB controls. The LED display is visible.

1.Disconnect the fryer from the electrical power supply.

2.Remove the three torx screws from the MIB cover, exposing the MIB board (see image at right).

3.Remove the screw in the center top will allow the board to hinge down and expose the connections on the back of the board.

4.Disconnect the MIB board by carefully removing the plugs on the rear of the board (see image at right).

5.Replace with a new MIB board and reverse steps to reassemble.

6.Once replaced, reconnect the power.

7.Cycle all power to the unit to readdress

the fryer using the steps on the previous page.

2 screws

Cover

1 screw

MIB controller cover (three screws hold it in place).

AIF Replacement

The AIF boards are located inside a protective housing underneath each frypot.

1.Disconnect the fryer from the electrical power supply.

2.Locate the AIF board to be replaced under a frypot.

3.Mark and unplug the harnesses.

4.Locate the screw on the front of the AIF assembly holding it in place.

5.Remove the screw and the front of the assembly drops down and the back tab slides out of the bracket attached to the frypot (see below).

6.Reverse steps to reassemble, ensuring that the new AIF assembly slides into the slot in the rear of the bracket.

7.Cycle all power to the unit to readdress the fryer using the steps on the previous page.

Remove this screw that secures the AIF board to the fryer.

After removing the screw, the AIF assembly drops down.

The bottom tab slides out of the bracket attached to the frypot.

39