Whenthe control knobis turned ON,gas will flow intothe burner. The solid state igniter will click as long as the knob is in the Lite position. (Note: All burner igniters will spark regardlessof whichburneris beingoperatedwhen a knob isturned to the Iite position.)
A properly adjustedburnerwith clean ports will light within a few seconds. On natural gas, the flame will be bluewith a deeper blue inner core. There should be no trace of yellowin theflame. A yellowflameindicatesan impropermixtureof air/gas. Thiswastes fuel, so havea servicemanadjustthe mixtureif a yellowflameoccurs. On LPgas,some yellowtipping is acceptable. This is normal and adjustment is not necessary.
The infinite surface controls provide flexibility in heat setting selection. (See page 7,)
In caseof prolongedpowerfailure, youcan manuallylight the surfaceburnerby holding alightedmatchnearthe burnerportsandslowlyturningthe controlknobcounterclockwise (after depressing)to the LJtesetting.
CAI,ITION: When lightingthe surface burner, besure all of the controlsare in the OFF position. Strikethe matchfirst andhold it in positionbeforeturning the knobto the Lite position.
Note: Becauseyour overhead hoodfan is electricit will notwork duringa power failure so smoke and condensationcan gather.
|
| COUNTERCLO£;KWlSE |
|
| t TO,NCREASELAME |
The Lo setting should produce a stableflame | _ | _1SLzE |
when turning the knob from Hi to Io. The | CLOCKW,SE.IIIIA | |
flame should extendto the outer edge of the | TO REDUCE |
|
FLAMESIZE |
| |
lipof theburnercaponthe Lo settingandmust be stable on all ports on Lo setting.
To adjust" Operate burner on Hi for about 5 STEM , , minutes to preheat burner cap. Turn knob
back to Lo; removeknob, and insert a small screwdriverinto the center of the valve stem.
Adjustflamesize by turningadjustmentscrew
in eitherdirectionwhile holdingthe valvestem VALVW securely.
Flamemust be of sufficientsize to be stable on all burnerports. If flame adjustmentis needed,adjust ONLY on the Lo setting. Never adjustflame size on a higher setting.
Note: All gas adjustments should be done by a qualified servicer only. 6
