Important Safety Instructions
24.This appliance has been tested for safe performance
using conventional cookware. Do not use any devices or accessories that are not specifically recommended in this
manual. Do not use eyelid covers for the surface burners or stovetop grills. The use of devices or accessories that are not expressly recommended in this manual can create serious safety hazards, result in performance problems and reduce the life of the components of the appliance.
25.Before servicing shut off electrical power supply to appliance.
26.Keep vent area unobstructed when in use.
WARNING
Electrical Grounding Instructions
The appliance is equipped with a
shock hazard | and should be plugged _ | ._"l_ |
directly into | a properly grounded /_ | _ |
remove the grounding prong from this plug.
IMPORTANTSAFETY NOTIC]
AND WARNING
The California Safe Drinking Water and Toxic Enforcen- Act of 1986 (Proposition 65) requires the Governor of C fornia to publish a list of substances known to the State
Californiato cause cancer or reproductive harm, andrequ businesses to warn customers of potential exposures to s
substances.
Users of this appliance are hereby warned that the burninl
gas can result in lowqevel exposure to some of the lk, substances, including benzene, formaldehyde and soot,,
primarily to the incomplete combustion of natural gas
liquid petroleum (LP) fuels. Properly adjusted burners _ minimize incomplete combustion. Exposure to these s
stances can be minimized by properly venting the cookto] the outdoors.
SAVE THESE INSTRUCTIONS
Ducting
Ducting Considerations
cooking fumes and smoke from the cooktop surface. If the
system does not, these are some ducting installation situations to check:
•6"diameter round or 3 Jh" x 10"rectangular ducting should be used for duct lengths
•No more than three 90 ° elbows should be used. Distance between elbows should be at least 18".
,Recommended
operating.
•There should be a minimum clearance of 6" for cook! installed near a side wall.
If there is not an obvious improper installation, there may a concealed problem such as a pinched joint, obstruction the pipe, etc. Installation is the responsibility of the instal and questions should be addressed first by the installer. _I installer should very carefully check the ducting installati instructions.