14
To install Sealed Burner Cartridge:
1. Be sure control knobs are turned OFF.
2. If the grill burner and grill grates are in place, remove
before installing a burner cartridge. Clean basin of any
grease accumulation. (See page 8 for cleaning
recommendations.)
3. Position the burner cartridge with the mixer tube openings
and igniter rods toward the orifices and terminal
receptacle. Slide the cartridge until the tubes and ignitors
engage, then lower the cartridge so that it rests on the
range surface.
To remove Sealed Burner Cartridge:
1. Control knobs should be in the OFF position and the
range should be cool.
2. Lift up the edge of the cartridge until the bottom of the
cartridge clears the basin. (Lifting the cartridge too high
while still engaged could damage the ignitor rods and
mixer tubes.)
The grill assembly consists of two grill grates and a grill
burner. Only install the grill on the LEFT SIDE of your range.
To Install Grill:
1. Before installing grill components, be sure controls knobs
are in the OFF position.
2. Position the grill burner with mixer tubes and ignitor rod
toward the orifices and terminal receptacle. Slide the
burner until the tubes and ignitor engage, then lower the
burner until it rests in the burner basin.
Sealed Burner CartridgeInstallationGrill Installation
3. To disengage the cartridge, hold by the sides and pull
away from the terminal receptacle and orifices. Lift out
when fully unplugged.
4. Do not stack cartridges where they may fall or be
damaged.
Important: Optional Sealed Burner Cartridge, model
JGA9150ADP, can replace the grill burner assembly. To
order, call 1-800-JENNAIR (1-800-536-6247).