Jenn-Air JDB8910, JDB9910 warranty Controls At a Glance, Operating Tips

Controls At A Glance

Delay/Resume

The Delay/Resume option can be used to automatically start the cycle at a later time, such as during off-peak hours for reduced energy usage or to reduce daytime heat

buildup in the home.

To Set Up a Delay:

Press and hold the Delay/Resume pad until the desired amount of delay time is selected. The delay time will begin counting down when the pad is released.

Select the appropriate cycle and options for the load.

The Delay/Resume indicator light will remain lit

until the delay time has counted down.

The cycle will automatically start as soon as the delay time expires.

I

Note: If Delay/Resume is chosen without selecting a cycle ] and/or options,the dishwasber will select the last cycle used.

(It will not remember the Rinse Only cycle.)

To Cancel a Delay:

Wait at least 2 seconds, then press the Delay/Resume pad again. The indicator light will go out and the cycle will start or resume immediately.

(continued)

Control Lock Option

The control touchpads can be locked to prevent unwanted use. If this feature is activated between cycles, the dish-

washer cannot be operated until the controls are unlocked. If desired, the controls can be locked after a cycle or delay

has started.

Note: This option does not lock the door, only the dish- washer controls.

Setting the Control Lock:

4, Press the _ pad for three seconds.

4' An indicator light will illuminate when the controls are locked.

To Cancel:

4, Press the_ pad for three seconds. The indicator light will go off.

Note: If a cycle or option pad is pressed after the con- troistimes,have been locked, the indicator light will flash five

Operating Tips

Starting The Dishwasher

After loading the dishwasher and adding detergent, close the dishwasher by pressing the door until the

latch clicks.

To start the dishwasher, firmly press the desired cycle and options pads. After a pause, the fill will begin. To prevent unplanned cycle or option

changes, these selections are "locked in" after 1 minute.

The indicator lights for the selected cycle and options will glow.

To cancel an option, press the pad again. To cancel a cycle, press the Drain/Off pad.

Adding a Forgotten Item

For best cleaning, the forgotten item should be added early in the cycle.

_ Press the Delay/Resume pad or unlatch the door.

•' Wait for the water circulation to stop.

•Open the door and add the item. Close and latch the door.

•If Delay/Resume was pushed, push it again to

restart the dishwasher.

After five seconds, the cycle resumes automatically at the point of interruption.

Note: Extended interruption of the wash cycle is not recommended.