Removing and Replacing the Automatic Ice Cube Dispenser Bin
Lift the front of the Automatic Dispenser bin and pull it straight out. Wash the bin
occasionally in mild soap and lukewarm water. To replace the bin, push it at1the way back until the bottom of the bin is behind the raised edge at the front of the shelf it rests upon. Make sure the tabs, at the back of the bin, that turn the spiral auger arepositioned between the prongs from the auger motor.
I Operating Your Automatic Ice and Water Dispenser { Water/Ice Control
For dispensing ice cubes, the slide control must be |
|
moved to the "Cube" position (center). For dispensing | _._,,,..,_ |
crushed ice, move the control to the "Crushed" position | _/- |
(left). | c |
I
movedFordispensingcomletelychilledtothewat"Water, ther" slidepoitionc ntro(right)l mus.t be | :I ( | _ | ii |
WaterfrothaOm,sponser,soh,,edce, ,dorwatar llil li
simpfirst glassaddiceOefof ,water dispensedispensingthewa,aro each tim m y b sormerthe.. liL: l]
than consecutive glasses. It will be cooler if a full glass of water is dispensed rather than a partial glass. Fill a container with ice before adding liquidto prevent splash- ing.
Dispensing
To fill a glass, position the glass against the top portion ofthe actuator pad andpress. Hold the glass high inthe
dispenser opening to reduce the ice falling outside_, the glass.
Some crushed ice may be dispensed even though you selected CUBE. This happens occasionally when a few cubes accidentally get channeled in the crusher,
When changingfromcrushediceto cubes somecrushed ice may bedispensed. This ma
sized cubes or ice chips are in the storage bin.
There may be adelay when you switch from cubes to crushed ice. Ittakes afew sect for the cubes to be channeled in the crusher. Crushed ice pieces will vary in size shape.
12
