Jenn-Air JRSF12250, JRS229, JRS207, JRSDE229, JRSD209, JRSD2450 I Location, Leveling Is Important

I Location ]

If you are installing your new refdgerator yourself, please follow these helpful su§ tions.

1. Remove base skids., [I J

Jii!: LJlJI

2.Remove all exterior and interior tape carefully and ._lli retain old tape. Make a small pad of this tape to pick

offany remainingtape residues. Thiswilleliminatethe '&_ need to use dangerous solvents of any kind.

3. Removeand discardthe cantilever shelf packingclips located just above each shelf where they hook onto

the frame. To remove the red plastic clip, wiggle it sideways and pull straight out.

4.Select a location for your new refrigerator away from any heat sources. Allow ; flow of air through the front base grille.

5.Your model should not be installed where the room temperature will go bel

55°F. because it will not run frequently enough to maintain proper temperat_ the freezer.

[Leveling Is Important I

To enhance its appearance, maintain efficient performance and for proper func the ice maker, your refrigerator should be level. Using a carpenter's level, ohec: refrigerator to make sure it is level front to back and side to side. The front wheel.' adjusted at the factory so the cabinet would be level. However, jarring in trar

standing the refrigerator onan uneven floormaycause the doors to shiftout of aligr ff leveling is necessary, remove the base grille and adjust the wheel with a scre_

as shown.

To lock the cabinet in place, turn down one or both					.o,_.c.,a_-r
locking feet, located near the front wheels. Rear
leveler feet are not required.
				TURNCOUNTER_t.OCk'_VI_E
! _L-_ !	TOCORRE_TTH,SCONDI*		[]
	TION, RAISE RIGHT	COR-		TO CORRECT	THIS CONOW[DN.
	NER AND/OR LOWER	LBFT		LEFT CORNER	AND/OR LOWER
	CORNER UNTIL DOORS			CORNERUNTILOOORSAUGN
	ALIGN ACROSS TOP		OF	TO_ OF CABINET.
	CABINET.
			4