INSTALLATION7
DUCTLESS CONVERSION
Ductless conversion is intended for applications where an exhaust duct work is not possible to be installed. When converted, the hood functions as a "purifying" hood rather than an exhaust hood. Fumes and exhaust from cooking is drawn and filtered by a set of optional Carbon Filters. The air is then purified and
We recommend to ALWAYS exhaust air outside of the home by employing existing or installing new duct work, if possible. The hood is most effective and efficient as an Exhaust unit. Only when the exhaust option is not possible should you recourse to converting the hood into a "purifying"unit.
When converted to be a "purifying" unit, a set of Carbon Filters are required on top of its standard Metal Filter set. Order according to its Part number below. The standard Metal Filters are intended to capture residue from cooking and the optional Carbon Filters help to purify fumes exhausted from cooking for
Carbon Filters (Required)
1. Purchase ductless Carbon Filters as follows:
Hood Model: | Part No. | Filters in pkg. |
JXT8030ADS JFLTRC8030 2
JXT8036ADS JFLTRC8036 3
JXT8042ADS JFLTRC8036 3
2. Remove metal filters on hood. Clip carbon filters onto each slot opening.
3.
4. Set filter change reminder for carbon filters.
When Off, hold 
for approx. 5 seconds. The display will change from 
(exhaust mode) to 
, (purifying mode/
carbon filters used) this indicates that the
elapse timer function is switched on and | Carbon Filter Dimensions: |
Carbon Filters are used. | 8.98 in x 6.38 in |
5. Carbon Filters must be replaced after | 228 mm x 162 mm |
| |
every 120 hours of use (or approximately |
|
every 2 to 3 months based on the average |
|
of |
|
microprocessor in the controls when set, |
|
will count usage time and indicate when |
|
carbon filter replacement is required. | 6" T connector |
| or 90 elbow |
Ducting | 6" straight pipe |
| |
1. Install a 6" straight pipe and a "T" connector/ | wall pipe strap |
or a 90 elbow to divert air through louvers on |
|
duct cover. |
|
