Jenn-Air JXT9036BDP, JXT9030BDP Connect the Wiring, Wiring Diagram, Finalize the Installation

CONNECT THE WIRING

WARNING: Risk of electrical shock. Electrical wiring must be done by qualified personnel in accordance with all applicable codes and standards. Before connecting wires, switch power off at service panel and lock service disconnecting means to prevent power from being switched on accidentally.

1.Remove wiring cover from rough-in plate and set aside.

2.Remove appropriate knock-out from rough-in plate. As you are installing the rough-in plate, feed 6” of power cable through knock-out opening and attach cable to wiring box with appropriate connector.

3.Connect BLACK to BLACK, WHITE to WHITE and GREEN or bare wire under GREEN ground screw. Reinstall wiring cover.

WIRING DIAGRAM

	120V 60Hz IN		B	TO FAN MOTOR
	W		B	B
NEMA
5-15P PLUG	G		HS	W
		THERMOSTAT		SPEED

CONTROL

B

RIGHT HEAT LAMP SWITCH

	RIGHT HEAT LAMP SOCKET
	B	W
FAN SWITCH
B		RIGHT LIGHT
	W	SOCKET
LIGHT	B	W

B SWITCH

CENTER LIGHT SOCKET

B

W

B		LEFT LIGHT SOCKET
	LEFT HEAT	B	W
	LAMP SWITCH
		LEFT HEAT LAMP SOCKET

TERMINAL BLOCK

W W

W

W W

W

W

B

W

FINALIZE THE INSTALLATION

OPTION

A Pro Style decorative soffit chimney is available - to hide ductwork if the hood is not installed under a cabinet. Refer to the instructions included with the soffit chimney.

Refer to page 5 for ordering information.

1.To install blower, refer to instructions included with blower / rough-in kit. Once the blower is installed, plug the blower unit into the female receptacle and the power supply onto the male connector inside the hood. DO NOT plug the two cords into each other.

See page 6 for blower / rough-in kit information.

HE0003

2.Install (2) heat lamp bulbs. Use BR40 size, 250W Max., infrared bulbs only (purchase separately).

Install (3) halogen light bulbs. Use PAR20 50W size (purchase separately).

10