ANTI-TIP DEVICE INSTALLATION INSTRUCTIONS
NOTE: A risk of range tip over exists if the appliance is not installed in accordance with the installation instructions provided. The proper use of this device minimizes the risk of
Installation instructions are provided for wood and cement in either floor or wall. Any other type of construction may require special installation techniques as deemed necessary to provide adequate fastening of the
STEP 1 - Locating The Bracket (see figure 5)
A.Determine where either the right or left rear “edge” of the range will be located and mark the floor or wall.
B.Place the BRACKET 15/16 from the marked “EDGE” toward center of opening and against the back wall as shown in figure 5.
C.Use the bracket as a template and mark the required holes, as shown in figure 5 for the type of construction you will be using.
STEP 2 - Anti-Tip Bracket Installation
A.Wood Construction:
1.Floor: Locate the center of the two holes identified in figure 5 as “HOLES FOR FLOOR”. Drill a 1/8 pilot hole in the center of each hole (a nail or awl may be used if a drill is not available). Secure the
2.Wall: Locate the center of the two holes identified in figure 5 as “HOLES FOR WALL. Drill an angled
1/8 pilot hole in the center of each hole as shown in figure 6. (A nail or awl may be used if a drill is not available). Secure the
B.Cement or Concrete Construction:
1.Suitable screws for concrete construction can be obtained at a hardware store. Drill the required size hole for the screws obtained into the concrete at the center of the holes identified in figure 5 as “HOLES FOR FLOOR”. Secure the
STEP 3 - Range Installation
A.Align the range to its designated location and slide it back into position. Make sure that the leveling foot is fully inserted into and secured by the
B.For safety considerations as well as optimum performance adjust the range so that it is level. This may be checked by placing a spirit level or a large pan of water on the cooktop or the oven rack.
C.To check the range for proper installation of the
D.Proceed with the remainder of the installation instructions.
FIGURE 5
FIGURE 6