Jenn-Air W10274320C Range Hood Use, Install Vent Covers, Complete Installation, Display, A B G

Models: LI3UUB W10274320C

1 32
Download 32 pages 34.81 Kb
Page 10
Image 10
RANGE HOOD USE

8.Seal connections with vent clamps.

A WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

9.Plug 3 prong power cord into a grounded 3 prong outlet located above the range hood.

RANGE HOOD USE

The range hood is designed to remove smoke, cooking vapors and odors from the cooktop area. For best results, start the hood before cooking and allow it to operate several minutes after the cooking is complete to clear all smoke and odors from the kitchen.

The range hood controls are located on the front side of the canopy.

A Install Vent Covers

B

G

Install Vent Covers

When using both upper and lower vent covers, push lower cover down onto hood and lift upper cover to ceiling and install with two 2.9 x 6.5 mm screws.

NOTE: For vented installations, the upper vent cover may be reversed to hide slots.

D

C

C DA

B

A. Upper vent cover

B. Lower vent cover

C. 2.9 x 6.5 mm screws

D. Bracket

Complete Installation

1.For non-vented (recirculating) installations only, install charcoal filters over grille on blower housing. See the “Range Hood Care” section.

2.Install metal filters. See the “Range Hood Care” section.

3.Check the operation of the range hood blower and light. See the “Range Hood Use” section.

NOTE: To get the most efficient use from your new range hood, read the “Range Hood Use” section.

C

F

 

D

E

A. Louver holes (non-vented

D. Grease filters

[recirculating] installations only)

E. Lamp housings

B. Duct covers

F. Grease filter handles

C. Canopy

G. Control panel

Control Panel

The range hood controls are located on the front side of the canopy.

A BCD E

A. Power decrease

B. Power increase

C.Display

D.Light

E.Timer

Display

Grease Filter Saturation Alarm

After 30 hours of fan function, the display will show “Clean Grease Filter” when the fan is active. When this icon shows in the display, the installed grease filters should be washed. See “Range Hood Care” section.

To reset the grease filter saturation alarm, press and hold the POWER INCREASE button for 5 seconds. The “Clean Grease Filter” icon will no longer be displayed.

10

Page 10
Image 10
Jenn-Air W10274320C Range Hood Use, Install Vent Covers, Complete Installation, Display, Control Panel, A B G, D C C A B