Level the Refrigerator Drawers
IMPORTANT:
■Overlay
■Before installing the refrigerator drawers, be sure that the countertop is level.
■If the countertop is not level, adjust the refrigerator drawers’ leveling legs until the appliance is square with the countertop. Be sure to maintain ³⁄₈" (9.5 mm) minimum gap between the top of the drawer and the countertop.
1.Open the top drawer and place the level across the top drawer as shown. Check the level from left to right.
A
NOTE: Be sure to recheck the horizontal level of the top drawer.
6.Be sure all four levelers are on the floor and supporting the full weight of the refrigerator drawers.
Install Custom Overlay Panel
IMPORTANT:
■Create a custom overlay panel according to the specifications in “Custom Overlay Drawer Panels.”
■
Attach the Overlay Panel
NOTE: If the overlay hooks are not installed, see “Custom Overlay Drawer Panels” for overlay hook locations.
1.Position the overlay panel ¹⁄₂" (1.27 cm) higher than the door. Be sure to position the overlay hooks to the pilot holes.
A. Check the level from left to right.
2.Turn the leveling legs (front and back) until the top drawer measures level from left to right.
3.Remove the level and close the top drawer. Check the gap between the top of the drawer and the countertop. If the gap measures less than ³⁄₈" (9.5 mm) minimum, turn all four leveling bolts equally to the left to raise the leveling legs (this will lower the appliance). Recheck the level.
4.Open both drawers less than midway. Place the level on the side flange beside the drawers as shown. Turn the front leveling bolts together in order to either raise or lower the appliance until the sides of the refrigerator drawers are plumb.
2.Insert the overlay hooks into the top of the holes in the door. Push against the overlay panel to force the overlay hooks deeper into the door. Pull the overlay panel straight down to secure the overlay hooks to the door.
3.Using a Phillips screwdriver, attach the overlay plates to the bottom of the overlay panel and door as shown.
A
A. Check the level from front to back.
5.Remove the level and close the drawers. Recheck the gap between the top of the drawer and the countertop. If the gap measures less than ³⁄₈" (9.5 mm), turn all four leveling bolts equally to raise the leveling legs (this will lower the appliance). Recheck the level.
A | B | C | D |
A. Overlay panel |
|
| C. Overlay plates (2) |
B. Door |
|
| D. |
Complete Installation
1.Remove all boxes, parts packages and packing materials from the interior of the refrigerator drawers.
2.Remove the film.
3.Clean the refrigerator drawers before use.
4.The controls are preset at the factory to the recommended settings. Be sure that the compressor is operating properly and that all the lights are working.
9
