Jenn-Air W10487492A warranty Using the Controls, Installing the Produce Preserver on some models

Installing the Produce Preserver (on some models)

CAUTION: IRRITANT

MAY IRRITATE EYES AND SKIN. DANGEROUS FUMES FORM WHEN MIXED WITH OTHER PRODUCTS.

Do not mix with cleaning products containing ammonia, bleach or acids. Do not get in eyes, on skin or clothing. Do not breathe dust. Keep out of reach of children.

FIRST AID TREATMENT: Contains potassium permanganate. If swallowed, call a Poison Control Center or doctor immediately. Do not induce vomiting. If in eyes, rinse with water for 15 minutes. If on skin, rinse with water.

The Produce Preserver pouches should be installed in their housing, which is located along an interior side wall of the crisper or convertible drawer.

		.
ATTENTION		revers
		le
		sur
NT
		prudences
	RITA
	IR
		des
		Lisez
		.
CAUTION		back
		Read
		T on
		N
		IR cautions
		ITA
		R

NOTE: For best performance, always use two pouches.

1.Remove the Produce Preserver pouches from their packaging.

CAUTION	ATTENTION
IRRITANT	IRRITANT
Read cautions on back.	Lire les mises en garde au dos.

Whirlpool Corporation, Benton Harbor MI 49022

2.Lift up on the housing in order to remove it from its mounting tab along the wall.

3.Open the housing by pulling up and out on the back of the top of the housing.

4.Place both pouches inside the housing, then snap the housing back together.

5.Place the housing back on the mounting tab along the wall.

Installing the Status Indicator (on some models)

The Produce Preserver comes with a status indicator, which should be activated and installed at the same time the pouch is installed.

REPLACE

MONTHS

1.Place the indicator face-down on a firm, flat surface.

2.Apply pressure to the bubble on the back of the indicator, until the bubble pops to activate the indicator.

3.Slide open the cap on the Produce Preserver housing.

4.Place the indicator in the top of the housing, facing outward.

5.Slide the cap closed, and check that the indicator is visible through the rectangular hole in the cap.

NOTE: The cap will not easily close if the indicator’s rear bubble has not been popped.

Replacing the Produce Preserver (on some models)

The disposable pouches should be replaced every 6 months, when the status indicator has completely changed from white to red.

To order replacements, see “Accessories.”

1.Remove the old pouches from the Produce Preserver housing.

2.Remove the old status indicator.

3.Install the new pouches and status indicator using the instructions in the previous sections.

Using the Controls

The refrigerator and freezer controls are located on the dispenser panel.

IMPORTANT: The display screen on the dispenser control panel will turn off automatically and enter “sleep” mode when the control buttons and dispenser pads have not been used for

2 minutes or more. While in “sleep” mode, the first press of a control button will only reactivate the display screen, without changing any settings. After reactivation, changes to any settings can then be made. If no changes are made within 2 minutes, the display will re-enter “sleep” mode.

■Touch any control button on the dispenser panel to activate the display screen. The home screen will appear as shown.

4