Jensen JCR-332 Technical Specifications, Care and Maintenance, Compliance with FCC Regulations

Models: JCR-332

1 5
Download 5 pages 28.07 Kb
Page 5
Image 5

NOTE : If the playing time of the CD is shorter than your selected sleep time, the music will stop at the end of the disc.

MORE INFORMATION

-Do not use your set immediately after moving from a cold place to a warm place. Condensation may build up and cause functional problems in the unit.

-Make sure that you keep your set away from water and high temperatures.

-Clean the player with a soft damp (never wet) cloth. Never use solvents.

NOTES ON COMPACT DISCS

-If there is a scratch, dirt or fingerprints on the CD, it may cause skipping or tracking errors. Before playing, clean the CD with a cleaning cloth. Wipe the CD from the center out. Don’t store discs in places with high temperatures or high humidity. They can become warped. After playing, store the CD in its case.

TECHNICAL SPECIFICATIONS

POWER SUPPLY : AC 120V ~ 60 Hz

Battery back-up - 9V 006P SIZE (not included)

RADIO :FM / Frequency Modulation - 88 / 108 MHz AM / Amplitude Modulation - 535 / 1705 kHz

CARE AND MAINTENANCE

1.Clean your unit with a damp (never wet) cloth. Solvent or detergent should never be used.

2.Avoid leaving your unit in direct sunlight or in hot, humid or dusty places.

3.Keep your unit away from heating appliances and sources of electrical noise such as fluorescent lamps or motors.

4.If drop-outs or interruptions occur in the music during CD play, or if the CD fails to play at all, its bottom surface may require cleaning. Before playing, wipe the disc from the center outwards with a good soft cleaning cloth.

5.Always clean the outside of the cabinet thoroughly if it becomes wet with moisture or water splashes. This will help to prevent the internal parts of the unit from entry of water and possible moisture damage.

COMPLIANCE WITH FCC REGULATIONS

This equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reason- able protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio technician for help.

WARNING:

Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

8

TROUBLE SHOOTING GUIDE

If you experience difficulties in the use of this music system,please check the followings or call 1- 800 - 777 - 5331 for Customer Service.

Symptom

Possible Cause

Solution

 

 

 

Noise or sound

Station not tuned properly for AM

Retune the AM or FM broadcast

distorted on AM or FM

or FM.

station.

broadcast.

FM: Wire antenna is not

Extend the FM wire antenna.

 

extended.

Reposition the unit until the best

 

AM: The bar antenna is not

reception is obtained.

 

positioned correctly.

 

 

 

 

FM STEREO Indicator

You have tuned to a mono

Select another FM station.

does not light.

station or the station is too weak.

Select FM STEREO mode.

 

MONO mode is chosen.

 

 

 

 

 

Unit not set to AM or FM band.

Slide the Function selector to AM

AM or FM no sound.

Volume at minimum.

or FM position.

 

 

Increase Volume.

 

 

 

 

Unit not in CD function mode.

Select CD function mode.

CD player will not play.

CD is installed incorrectly.

Insert CD with label side up.

 

If the CD is self-compiled, the

Use better quality blank media and

 

media used may not be

retest.

 

compatible with the player.

 

 

 

 

CD skips while playing.

Disc is dirty or scratched.

Wipe CD with clean cloth or use

 

 

another disc.

 

 

 

CD Intermittent sound.

Dirty or defective disc.

Clean or replace the defective disc.

 

Dirty Pick Up lens.

Use a CD-lens cleaning disc to

 

Player is subject to excessive

clean the lens.

 

shock or vibration.

Relocate the player away from

 

 

shock or vibration.

SERVICE

Please refer to the instructions on the enclosed warranty card for returning your unit for service. When returning the unit, please remove batteries to prevent damage to the unit in transit and/or from possible battery leakage. We are not responsible for batteries returned with the product or for the cost of replacement.

Distributed by:

Spectra Merchandising International, Inc. Chicago Industry Tech Park

4230 North Normandy Avenue Chicago, IL 60634, U.S.A.

Please have model number ready, for Customer Service, call 1-800-777-5331

Printed in China

9

CRD-732X IB JENS 001 REV0 GB.p65

5

2008-5-6, 11:50

Page 5
Image 5
Jensen JCR-332 Technical Specifications, Care and Maintenance, Compliance with FCC Regulations, Trouble Shooting Guide