10
RADIO OPERATIONS
SETTING THE CLOCK
In case the back-up batteries are accidentally removed. You will need to set the clock
manually.
If the LED display is blinking
1. In standby mode, press the UP button to increase or press the DOWN button to
decrease the minutes setting.
2. Press and hold the UP / DOWN button to fast forward/backward the clock setting.
3. Press the MEM/SET button to confirm the setting.
If the LED display is steady
1. In standby mode, press and hold MEMORY/SET button for 3 seconds, Time flashes
on LED display when the time is AM,”PM” and time flashes on LED when time is PM.
2. Press the UP button to increase or press the DOWN button to decrease the minutes
setting.
3. Press and hold the UP / DOWN button to fast forward/backward the clock setting.
4. Press the MEMORY/SET button again to confirm the setting.
LISTENING TO RADIO
1. Press the power ON/OFF button to turn on the unit.
2. Press the FUNCTION button to select AM or FM radio mode. The AM or FM band
radio frequency will appear on the display.
3. To manually tune the radio station, press the TUNE + or TUNE − button repeatedly.
4. To automatically scan to the next radio station with the strongest signal, press and
hold the TUNE + or TUNE − button for 1-2 seconds until frequency readout on the
display begins to scan and then release the button. The tuner will stop scanning when
it receives the next strongest station signal.
5. Press the VOLUME+/VOLUME – button to ajust the volume to your desired listening
level.
6. When you have finished listening, press the “ON/OFF” button to turn off the unit.
NOTE
There is a PM indicators located in the right-hand corner of the clock display. If it
turns off, that means the time is AM. Be sure to observe the correct AM / PM time
when setting the alarm to make sure the wake time is set correctly for AM or PM.