Jensen KT2056 owner manual Listening to the Radio, Antenna Information, Wake to Radio

LISTENING TO THE RADIO

1.Set the BAND selector to the desired band, AM or FM.

2.Set the VOLUME control to a low setting.

3.Slide the ALARM switch to the ON position.

4.Select your desired station with the TUNING control.

5.Adjust the VOLUME control to a desired setting.

6.When you finished listening, slide the ALARM selector to the OFF position to turn the radio 'Off'.

ANTENNA INFORMATION

AM - The AM bar antenna is inside the cabinet. If the AM reception is weak, change the position of the cabinet until the internal antenna picks up the strongest signal

FM - The FM antenna is built-in to the AC power cord. If the FM reception is weak try varying the position and direction of the power cord until you find the strongest signal.

WAKE TO RADIO

1. Slide the ALARM selector to the ON position and select the band, station, and volume level that you wish to hear when the alarm comes 'On', then slide the ALARM selector to the AUTO position and the ALM indicator will light up.

2. Reconfirm the wake up time settings by pressing the ALARM button.

3.The radio will turn 'On' at the selected wake up time. It will play for about two hours and then shut off automatically.

4.To stop the radio sooner, press the ALARM button. The radio will stop but the alarm remains set and will turn the radio on again at the same time on the following day.

5.If you do not want the alarm to turn the radio on on the following day, set the ALARM selector to the 'OFF' position.

8