Jensen MCD5070 operation manual DIN Rear Mount Method B, Reconnect Battery

MCD5070

DIN Rear Mount (Method B)

This unit has threaded holes in the chassis side panels which may be used with the original factory mounting brackets of some vehicles to mount the radio to the dashboard. Please consult with your local mobile stereo shop for assistance on this type of installation.

1.Remove the existing factory radio from the dashboard or center console mounting. Save all hardware and brackets as they will be used to mount the new radio.

2.Carefully unsnap the plastic trim ring from the front of the new radio chassis. Remove and discard the trim ring.

3.Remove the factory mounting brackets and hardware from the existing radio and attach them to the new radio. Select

a position where the screw	Screws
holes of the bracket and the
screw holes of the main unit	Dashboard
are aligned (are fitted).
Tighten the screws at 2
places on each side. Do not	Factory
exceed M5 x 9 MM maximum
	Mounting
screw size. Longer screws
	Bracket
may damage components	Hook (Remove)
inside the chassis.

4.Wire the new radio to the

vehicle as outlined in the Universal Installation instructions.

5.Mount the new radio assembly to the dashboard or center console using the reverse procedure of step 1.

NOTE: The mounting box, outer trim ring, and half-sleeve are not used for method B installation.

Reconnect Battery

When wiring is complete, reconnect the battery negative terminal.

4