Jensen MP6211 Preparation, Tools and Supplies, Pre-installation, Disconnect Battery

PREPARATION

Tools and Supplies

The following tools and supplies are needed to install the radio.

•Torx type, flathead and Philips screwdrivers

•Wire cutters and strippers

•Tools to remove existing radio (screwdriver, socket wrench set or other tools)

•Electrical tape

•Crimping tool

•Volt meter/test light

•Crimp connections

•18 gauge wire for power connections

•16-18 gauge speaker wire

SPEAKER REQUIREMENTS: Only connect speakers rated in the load impedance of 4 ohms. Speakers with a load impedance less than 4 ohms could damage the unit.

MP6211

Pre-installation

1.Disconnect Battery

Before you begin, always disconnect the battery negative terminal.

2.Remove Transport Screws

3.Remove Radio from Sleeve

Lift latches on both sides of sleeve to remove half-sleeve from radio.

TRANSPORT

SCREWS

HALF

SLEEVE

2