MP6211
WIRING
WIRING DIAGRAM
Wiring with a Wiring Adapter (Purchased Separately)
Connect Wires
You can make these connections without being in the vehicle.
1.Splice or crimp wires.
2.Attach wiring adapter to car wiring harness.
Wiring Diagram / Color Codes
1.Power Antenna (dark blue wire) - Connect to power antenna or amplifier. If not used, tape bare end of wire.
2.Accessory/Ignition (red wire) - Connect to existing radio wire or radio fuse.
3.Ground (black wire) - Connect to ground terminal or clean, unpainted part of chassis.
4.Memory/Battery (yellow wire) - Connect to battery or 12 volt power source that is always live. The radio will not work if this wire is not connected.
5.Antenna Connector - Connect the antenna plug from the existing antenna cable (some vehicles require an adaptor).
6.CD Changer/JPORT connector - Use this
7.Auxiliary Input Cable (yellow RCA cables) - Connect line in for auxiliary input devices (CD player, etc.).
8.Outputs to Amplifier (gray RCA cables) - Connect line out for optional external amplifiers. The red connector is for the right and the white connector is for the left.
9.Left Front Speaker
10.Right Front Speaker
11.Left Rear Speaker
12.Right Rear Speaker
NOTE: The amplifier in this radio is only designed for use with four speakers. Never combine (bridge) outputs for use with two speakers. Never ground negative speaker leads to chassis ground. Failure to wire exactly as shown may cause electrical damage to the radio.
Fuses
When replacing a fuse, make sure the new fuse is the correct type and amperage. Using an incorrect fuse could damage the radio. The MP6211 uses one 15 amp fuse located below the wiring connector (15 amp fast blow ATO).
Reconnect Battery
When wiring is complete, reconnect the battery negative terminal.
Technical Assistance
Optional JPORT (Sold Separately)
If you require assistance, contact Technical Support at
3
