INSTALLATION

This unit is designed for installation in cars, trucks and vans with an existing radio opening. In many cases, a special installation kit will be required to mount the radio to the dashboard. These kits are available at electronics supply stores and car stereo specialty shops. Always check the kit application before purchasing to make sure the kit works with your vehicle. If you have trouble locating a kit or need installation assistance, contact Technical Support at 1-800-323-4815 from 8:30am to 7:00pm EST Monday through Friday and from 9:00am to 5:00pm EST on Saturday.

Tools and Supplies

The following tools and supplies are needed to install the radio:

Torx type, flathead and Philips screwdrivers

Wire cutters and strippers

Tools to remove existing radio (screwdriver, socket wrench set or other tools)

Electrical tape

Crimping tool

Volt meter/test light

Crimp connections

18 gauge wire for power connections

16-18 gauge speaker wire

MP6212

Preparation

1.Disconnect Battery

Before you begin, always disconnect the battery negative terminal.

NOTE: If the MP6212 is to be installed in a car equipped with an on- board drive or navigation computer, do not disconnect the battery cable. If the cable is disconnected, the computer memory may be lost. Under these conditions, use extra caution during installation to avoid causing a short circuit.

2.Remove Transport Screws

TRANSPORT

SCREWS

HALF

SLEEVE

MP6212

/

3.Remove Radio from Sleeve

Lift latches on both sides of sleeve to remove half-sleeve from radio.

2

Page 4
Image 4
Jensen MP6212 instruction manual Installation, Tools and Supplies, Preparation