Jensen SB6051 manual Playing Phono Records, Auto-Stopswitch Operation, Hints For Best Reception

HINTS FOR BEST RECEPTION:-

-AM: THE RECEIVER HAS A BUILT-IN AM BAR ANTENNA. IF AM RECEPTION IS WEAK, SLIGHTLY ROTATING OR RE-POSITIONING OF THE UNIT WILL USUALLY IMPROVE THE AM RECEPTION.

-FM: THE RECEIVER HAS A BUILT-IN FM WIRE ANTENNA (15). THIS WIRE SHOULD BE TOTALLY UNRAVELED AND EXTENDED FOR BEST RECEPTION. IF FM RECEPTION IS WEAK TRY REPOSITIONING THE FM WIRE ANTENNA UNTIL YOU FIND THE STRONGEST FM SIGNAL.

PLAYING PHONO RECORDS

1.RAISE THE TURNTABLE DUST COVER.

2.REMOVE THE STYLUS PROTECTOR AND RELEASE THE TONE ARM CLAMP (12).

3.SET THE FUNCTION SELECTOR (5) TO “PHONO”.

4.PLACE A RECORD ON THE TURNTABLE, OVER THE CENTER SPINDLE.

5.SET THE SPEED SELECTOR SWITCH (11) TO 33, 45 OR 78 RPM ACCORDING TO THE RECORD YOU ARE PLAYING. PLACE THE INCLUDED 45 RPM ADAPTOR (10) OVER THE CENTER SPINDLE WHEN PLAYING 45 RPM RECORDS.

6.MOVE THE TONE ARM TO THE BEGINNING OF THE RECORD OR TO THE BEGINNING OF A PARTICULAR TRACK. GENTLY LOWER THE TONE ARM ONTO THE RECORD TO START PLAYING.

7.ADJUST THE VOLUME IF NEEDED. THE TURNTABLE WILL STOP AUTOMATICALLY WHEN THE RECORD FINISHES.

8.TO STOP THE RECORD BEFORE IT ENDS, LIFT THE TONE ARM AND RETURN IT CAREFULLY ONTO THE TONE ARM CLAMP (12).

9.REPLACE THE STYLUS PROTECTOR ON THE STYLUS WHEN NOT IN USE.

IMPORTANT:

I.DO NOT STOP OR TURN THE PLATTER MANUALLY.

II.MOVING OR JARRING THE TURNTABLE WITHOUT SECURING THE TONE ARM CLAMP COULD RESULT IN DAMAGE TO THE TONE ARM.

AUTO-STOP SWITCH OPERATION

THE AUTO-STOP AREA ON SOME RECORDS MAY EXTEND BEYOND THE PRESET SETTING. AS A RESULT THE TURNTABLE COULD POSSIBLY STOP BEFORE THE LAST TRACK FINISHES. IF YOU EXPERIENCE THIS DURING PLAYBACK, SET THE AUTO-STOP SWITCH (13) LOCATED ON THE BACK OF THE UNIT TO THE “OFF” POSITION. THE TURNTABLE WILL NOW RUN TO THE END OF THE RECORD BUT WILL NO LONGER STOP AUTOMATICALLY. TO STOP THE TURNTABLE YOU WILL NEED TO EITHER SET THE FUNCTION SELECTOR (5) TO ANOTHER POSITION OTHER THAN PHONO OR RETURN THE AUTO-STOP SWITCH (13) TO THE “ON” POSITION. AFTER THE RECORD STOPS, LIFT AND RETURN THE TONE ARM CAREFULLY BACK ONTO THE TONE ARM CLAMP (12).

5