VM8012
WIRING
Subwoofer Out
Parking SW (Active Low Level Input)
NOTE: The amplifier in this radio is |
|
only designed for use with four |
|
speakers. Never combine (bridge) |
|
outputs for use with two speakers. |
|
Never ground negative speaker |
|
leads to chassis ground. Failure to |
|
wire exactly as shown may cause | Ground |
electrical damage to the radio. | Connect to ground terminal |
| or clean, unpainted part of chassis. |
Video In
Video Out
USB Slot
Fuse (15A)
Rear Line out | R (Red) |
Gray | L (White) |
FrontLine out | R (Red) |
Black | L (White) |
Power Antenna
R(Red) L (White) (Yellow)
(Yellow)
A/V Media Adapter Cable
NOTE: Only connect speakers with a nominal impedance of 4 ohms. Speakers with a load impedance less than 4 ohms could damage the unit.
Black
Memory/Battery
Connect to battery or 12 volt power source that is always live. The radio will not work if this wire is not connected.
Yellow
Connect to power antenna or amplifier. If not used, tape bare end of wire.
Blue
Accessory/Ignition Connect to existing radio wire or radio fuse.
Red
IMPORTANT!
FRONT SP
REAR SP
The pink parking wire MUST
White/Black | White Gray/Black | Gray | Green/Black | Green Purple/Black | Purple |
Stripe | Stripe |
| Stripe | Stripe |
|
Left Speaker | Right Speaker | Left Speaker | Right Speaker |
(Front) | (Front) | (Rear) | (Rear) |
be connected to the switched side of the parking break circuit (the part that becomes grounded when the brake is applied).
3
