Jensen VM9020TS operation manual Multi-Zoneoperation, Exiting the System Setup Menu

							VM9020TS
						MULTI-ZONE OPERATION
submenu appears in a second row with the selected							Selecting a Source for the Rear Zone
option highlighted in light blue.						Independent sources can be played simultaneously on the	To access the rear zone SOURCE MENU, touch the top right
2. Select a new value by pressing the			or		buttons (14,		corner of the screen, near the Multi-ZONE icon.
22) on the remote control or the or			buttons (6, 7) on			VM9020TS. For example, a video game console can be seen
the joystick.						on the front screen while DVD video is available to rear
3. Confirm your selection by pressing the				,	, or	passengers. For example, DVD is selected as the front
buttons (14, 17, 19) on the remote control, or the or						source and SD Card is selected for the rear source or SD
button (8, 9) on the joystick. The new value is						Card is selected as the front source and DVD is selected for
highlighted in light blue and setup is complete.						the rear source. In the first case, both sources will switch to
Table 7: ASP Config Menu Features						SD Card. In the second case, both sources will switch to the
						DVD source because the multimedia processor is shared
Setting	Options	Function				between optical and SD Card media.
						Selecting a Source for the Front Zone
Bass Center	60Hz	According to the audio source, select
						To access the FRONT ZONE SOURCE MENU, touch the
Freq		the Bass Center Frequency to
	80Hz
		achieve the best Bass effect.				TFT screen in the top left corner of the screen.
	100Hz
	130Hz
	150Hz
	200Hz						Select the source to be directed to the rear Multi-ZONE RCA
Treble Center	10KHz	According to the audio source, select					outputs.
Freq		the Treble Center Frequency to
	12.5KHz
		achieve the best Treble effect.
	15KHz						NOTE: Optical media and an SD Card cannot be selected
	17KHz						from the Multi-ZONE Source Menu icon simultaneously.
Sub.W Filter	80Hz	Selecting a crossover frequency sets
		a cut-off frequency of the subwoofer's
	120Hz
		LPF (low-pass filter) and the					NOTE: The AM/FM tuner graphics will change to a "blue
	160Hz	“SMALL” speakers' HPF (high-pass					screen" background when any optical or SD Card media
		filter). The Crossover frequency set-
							is selected from the Multi-ZONE menu. In addition, only
		ting has no effect if the subwoofer is
		set to “OFF” and any other speaker is					the top left (Front Zone Source Menu) and right (Multi-
		set to “LARGE”.					ZONE Source Menu) quadrants of the touch screen are
							active during this mode of operation.
Sub.W Phase	0D	Subwoofer output IN phase
	180D	Subwoofer output OUT OF phase				This menu allows you to select a source for the front zone.
		NOTE: Depending on your installa-
		tion, reversing the subwoofer phase
		may increase Bass output.
Bass Q-Factor	1.0	When the Bass Center Frequency is
		selected, adjusting the Bass Q-Fac-
	1.25
		tor alters the sharpness of the Bass
	1.5	output.
	2.0
BACK		Return to previous menu.

Exiting the System Setup Menu

To exit setup mode and resume normal playback, press the SYS SETUP button (31) on the remote control or the DISP button (13) on the front panel.

12