Jensen VM9510TS operation manual MULTI-ZONE Operation, Exiting the System Setup Menu

VM9510TS

submenu appears in a second row with the selected						MULTI-ZONE OPERATION	Selecting a Source for the Rear Zone
option highlighted in light blue.						Independent sources can be played simultaneously on the	To access the rear zone SOURCE MENU, touch the top right
2. Select a new value by pressing the			or		buttons (14,		corner of the screen, near the Multi-ZONE icon.
22) on the remote control or the or				buttons (18, 19)		VM9510TS. For example, a video game console can be seen
on the joystick.						on the front screen while DVD video is available to rear
3. Confirm your selection by pressing the				,	, or	passengers.
buttons (14, 17, 19) on the remote control, or the or
button (16, 17) on the joystick. The new value is						NOTE: If DVD is selected as the front source and SD
highlighted in light blue and setup is complete.						Card is selected for the rear source, then both sources
Table 7: ASP Config Menu Features						will switch to SD Card. If SD Card is selected as the front
						source and DVD is selected for the rear source, then
						both sources will switch to the DVD source. Since the
Setting	Options	Function				multimedia processor is shared between optical and SD
						Card media, one of the other can be selected but not
Bass Center	60Hz	According to the audio source, select				both simultaneously.
Freq	80Hz	the Bass Center Frequency to
		achieve the best Bass effect.
						Selecting a Source for the Front Zone
	100Hz
						To access the FRONT ZONE SOURCE MENU, touch the
	130Hz
						TFT screen in the top left corner of the screen.
	150Hz
	200Hz						Select the source to be directed to the rear Multi-ZONE RCA
Treble Center	10KHz	According to the audio source, select
							outputs.
Freq		the Treble Center Frequency to
	12.5KHz
		achieve the best Treble effect.
	15KHz						NOTE: Optical media and an SD Card cannot be selected
	17KHz						from the Multi-ZONE Source Menu simultaneously.
Sub.W Filter	80Hz	Selecting a crossover frequency sets
		a cut-off frequency of the subwoofer's
	120Hz
		LPF (low-pass filter) and the					NOTE: The AM/FM tuner graphics will change to a "blue
	160Hz	“SMALL” speakers' HPF (high-pass					screen" background when any optical or SD Card media
		filter). The Crossover frequency set-
							is selected from the Multi-ZONE menu. In addition, only
		ting has no effect if the subwoofer is
		set to “OFF” and any other speaker is					the top left (Front Zone Source Menu) and right (Multi-
		set to “LARGE”.					ZONE Source Menu) quadrants of the touch screen are
							active during this mode of operation.
Sub.W Phase	0D	Subwoofer output IN phase
	180D	Subwoofer output OUT OF phase
		NOTE: Depending on your installa-
		tion, reversing the subwoofer phase				This menu allows you to select a source for the front zone.
		may increase Bass output.
Bass Q-Factor	1.0	When the Bass Center Frequency is
		selected, adjusting the Bass Q-Fac-
	1.25
		tor alters the sharpness of the Bass
	1.5	output.
	2.0
BACK		Return to previous menu.

Exiting the System Setup Menu

To exit setup mode and resume normal playback, press the SYS SETUP button (31) on the remote control or the DISP button (5) on the front panel.

13