VR182
REMOTE CONTROLLERS
Steering Wheel Remote (SOLD SEPARATELY)
Installing the Steering Wheel Remote
Use the mounting bracket to attach the remote control to the steering wheel:
1.Use the screwdriver to remove the two screws on the bottom of the mounting cabinet and remove the cabinet.
2.Unfold the binding, then let the binding surround the pole of the steering wheel tightly. Adhere the
3.Use the two screws to fix the mounting cabinet to the mounting base.
Binding
Mounting Base
Mounting Base
Mounting Cabinet
Screws
Screwdriver
4.Fix the remote control to the mounting cabinet. Aim the outshoot on the mounting cabinet to the groove on the side of the remote control.
Inserting the Battery
1.To open the battery compartment cover, push the cover marked “OPEN” on the back of the remote control.
2.Insert the new battery (CR2025 3V) into the battery compartment. Make sure the positive and negative terminals of the battery are oriented as indicated.
3.Close the cover.
Battery Cover
Key Functions
•UP/DN: Navigates presets in AM/FM/WB/SAT modes.
•SEEK
•ENT: Enter key.
•WB: Directly accesses weatherband.
•MODE: Cycles through all available play modes (Radio, CDP, CDC, SAT, iPod, Aux).
Groove
Outshoot
Remote Control
Mounting Bracket
5.If the main unit is placed on the right side of the steering wheel, to operate the unit conveniently, you can install the remote control on the right pole of the steering wheel, then you can use the right hand to press the keys on the remote control to control the main unit.
NOTE: If CDC, SAT or iPod hardware is not connected, the corresponding mode will be skipped in the sequence.
•POWER: Powers on/off.
•MUTE (Play/Pause): Mutes audio in all modes. Pauses/resumes play in CDP/CDC/iPod modes.
•BAND: Sequences
•VOLUME
14