Jensen VR182 Care And Maintenance, Credit Card Remote SOLD SEPARATELY, Ignition, Interference

VR182

Credit Card Remote (SOLD SEPARATELY)

CARE AND MAINTENANCE

•	POWER: Powers on/off.
•	MOD: Cycles through all available play	POWER		VOL	MENU
	modes (Radio, CDP, CDC, SAT, iPod, Aux).
•	VOL: Adjusts volume level.		MOD		AUD
•	AUD (MENU): Accesses Audio and System		TUNE/CH	S-MOD	TUNE/CH
	Menu.	MUTE		ENT
•	ENT (S-MOD): Enter key.
•	TUNE/CH +/-: Changes frequency/channel			VOL	EXIT/SCH
	by one step in AM/FM/SAT modes.	WB	BAND		AS/PS
•	MUTE: Mutes audio in all modes.
•	WB: Directly accesses weatherband.	RPT	SCAN	SHUF	SCROLL
•	BAND: Sequences bands/preset-banks	1	2	3	DISP
	(FM1, FM2, AM) in Radio mode. Sequences		DN DISC/DIR UP		LOUD
	preset banks (SAT1, SAT2, SAT3) in satellite
		4	5	6	EQ
	mode.
•	AS/PS (EXIT/SCH): Scans all stored presets			CATEGORY
	in SAT or radio mode (any button press	PTY	TA
	during PS will stop the scan).

•DISP (SCROLL): Sets clock. Scrolls ID3 information.

•DN/DISC/UP: Moves to next/previous disc in CDC mode.

•EQ (LOUD): Turns on/selects preset Equalizer functions.

•PTY: Cycles though a list of RDS program types in FM radio mode (seek +/- is pressed to search the band for the selected program type). Scans all stored presets in SAT mode (any button press during PS will stop the scan).

•TA: Enters Traffic Announcement mode.

•CATEGORY </>: Changes category in SAT/iPod mode.

•Keep the product dry. If it does get wet, wipe it dry immediately. Liquids might contain minerals that can corrode the electronic circuits.

•Keep the product away from dust and dirt, which can cause premature wear of parts.

•Handle the product gently and carefully. Dropping it can damage circuit boards and cases, and can cause the product to work improperly.

•Wipe the product with a dampened cloth occasionally to keep it looking new. Do not use harsh chemicals, cleaning solvents, or strong detergents to clean the product.

•Use and store the product only in normal temperature environments. High temperature can shorten the life of electronic devices, damage batteries, and distort or melt plastic parts.

Ignition

The most common source of noise in reception is the ignition system. This is often a result of the radio being placed relatively close to the ignition system (engine). This type of noise can be easily detected because it will vary in intensity of pitch with the speed of the engine.

Usually, the ignition noise can be suppressed considerably by using a radio suppression type high voltage ignition wire and suppressor resistor in the ignition system. (Most vehicles employ this wire and resistor, but it may be necessary to check them for correct operation.) Another method of suppression is the use of additional noise suppressors. These can be obtained from most CB/A radio or electronic supply shops.

Interference

Radio reception in a moving environment (automobile) is very different from reception in a stationary (home) environment. AM reception will deteriorate when passing through a tunnel or when passing under high voltage lines. Noise can be picked up from passing automobiles. Although AM is subject to environmental noise, it can received at great distances. This is because broadcasting signals follow the curvature of the earth and are reflected back by the upper atmosphere.

15