XA2125, XA275, XA250 | ® | |||
|
| |||
Troubleshooting | ||||
|
|
|
| |
| Problem | Possible Cause | Corrective Action | |
|
|
|
| |
| Amplifier does not operate | No power to +12V terminal | Repair wire or connections. | |
| (power LED not on) when |
|
|
|
| vehicle and radio are on | No power to remote wire with radio on | Check connections to radio with test light. | |
|
|
|
| |
|
| Fuse blown | Check fuse. | |
|
|
|
| |
| Radio volume needs to be | Input level control adjusted too low | Adjust input level control. | |
| turned up too high for amp |
|
|
|
| to work |
|
|
|
|
|
|
| |
| Radio volume is too sensitive | Input level control adjusted too high | Adjust input level control to lower setting. | |
|
|
|
| |
| Sound from only one speaker | Defective speaker | Replace speaker. | |
|
|
|
| |
|
| Poor connections to speaker (wire) | Check connections. | |
|
|
|
| |
|
| RCA input cable defective | Replace cable. | |
|
|
|
| |
|
| Input level control adjusted too high | Adjust input level control. | |
|
|
|
| |
| Sound distorted | Speaker wires shorting together | Separate speaker wires and insulate. | |
|
|
|
| |
| Blows fuses | Power wires hooked up incorrectly | Check power wire connections. | |
|
|
|
| |
|
| Speakers blown or defective | Check speakers. | |
|
|
|
| |
| Engine noise | Improper ground connections | Reroute RCA away from main power wires. | |
| (Ignition noise/static or | Ground loop(s) |
|
|
| Alternator whine) |
| Reroute RCA cable. | |
|
|
|
| |
|
|
| Make sure amp is grounded to a clean, solid part of the chassis/frame. | |
|
|
|
| |
| Protect light comes on/ | Amp is in thermal protection | Let amp cool down before attempting to turn back on (some installations may | |
| amplifier shuts down |
| require a fan to keep the amp cool, especially if you are driving subwoofers with | |
|
|
| the amp). | |
|
|
|
| |
|
| Faulty speaker connection and/or | Check speakers and/or crossovers for loose or bad connections. | |
|
| crossover |
|
|
|
|
|
| |
|
| Low battery voltage | Make sure you are getting between | |
|
|
| multimeter measured at the amplifier. | |
|
|
|
| |
|
| Speaker impedance less than 2 ohms | If you are using 4 ohm speakers you cannot have more than two speakers wired | |
|
| per channel | in parallel per channel. Amp will not operate into 2 ohms bridged. | |
|
|
|
| |
| No output on channels | Speaker wires not connected to | Refer to pages 6 – 8 for proper installation. | |
|
| speakers properly |
|
|
|
|
|
|
|
|
| Input hooked up incorrectly |
|
|
|
|
|
|
|
11
6236 XA2CH_E.p65 | 11 | 5/7/01, 2:07 PM |
